Installation Guide

- 4 - NetWayG

6. When the use of stand-by batteries is required, they must be sealed lead acid or gel type. Connect four (4)

12VDC batteries in series to terminals marked [+ BAT –] (Fig. 2h, pg. 4), carefully observing polarity.

Note: When batteries are not used a loss of AC will result in a loss of output voltage.

7. Manual Reset NetWay8G/NetWay8GP:

Depress button for 3 seconds via pin hole marked RESET on front of unit.

Manual Reset NetWay16G: This will require opening the unit.

CAUTION: Disconnect 115/230VAC prior to opening unit. To manage network settings via USB,

or reset to factory default settings via reset button proceed to open top of enclosure chassis removing screws

(set screws aside). Plug laptop into USB port to manage and review network settings via Altronix Dashboard

as needed. To restore to factory default via manual reset, proceed to open unit as described above and depress

reset button (for 3 secs.) located on board. Close enclosure with screws and power unit once again.

Fig. 2

NetWay8G/NetWay8GP:

2a OUT 1-8 (1-16): Structured cable to PoE compliant cameras/edge devices.

2b IN 1-8 (1-16): Structured cable to ethernet switch or video server.

2c LED(s) 1-8 (1-16): Port status LEDs.

2d Manual Reset: Restores unit to factory settings.

NetWay8G/NetWay8GP: Located on front of unit.

NetWay16G: Located internal (refer to installation instructions above)

2e USB Port

NetWay8G/NetWay8GP: Located on front of unit.

NetWay16G: Located internal (refer to installation instructions above)

2f Ethernet Port

2g IEC 320 Connector: 115/230VAC (grounded line cord included).

2h Built-in battery charger: Charges stand-by batteries for applications requiring back-up,

(optional rack mount battery enclosure available - RE2)

NetWay16G

NetWay8G/8GP - Rear Panel

NetWay8G/8GP - Front Panel

2a 2b 2c

2h2g

OUT

AC POWER

1 2345 678910 11 12 13 41 15 16

NetWay16G - Front Panel

NetWay16G - Rear Panel

2h2g