Installation Guide

- 6 - NetWay8GL
NetWay8GL Typical Applications:
Fig. 4
Card
Reader
HID Solo
Strike
Ethernet Switch
Programming
and Status
NVR/Network Server
Typical UL294
Application:
PoE/PoE+/Hi-PoE
Camera
PoE/PoE+/Hi-PoE
Camera
PoE/PoE+
Camera
NetWay8GL
Front Panel
NetWayXT/NetWayXTX
Extends Ethernet
100m
NetwayXT
Repeater
I.T.E. 43KC
www.altronix.com
Made in U.S.A.
Configuring NetWay8GL for Network Connection
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Please be sure to visit altronix.com for latest firmware and installation instructions
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Factory Default Settings
• IP Address: 192.168.168.168
• User Name: admin
• Password: admin
1. Set the static IP address for the laptop to be used for programming to the same network IP address as the
NetWay8GL. The default address of the NetWay8GL is 192.168.168.168, E.I. 192.168.168.200.
2. Connect one end of the network cable to the network jack on the NetWay8GL and the other to the network
connection of the laptop.
3. Open a browser on the computer and enter “192.168.168.168” into the address bar. A dialog box
Authentication Required will appear requesting both user name and password.
Enter the default values here. Click on the button labeled Log In.
4. The status page of the NetWay8GL will appear. Click on the tab labeled Network Settings. This will open
the Network Setting screen. In this screen the MAC Address of the NetWay8GL module will be found
along with the Network Settings and Email Settings.
Network Settings:
In the IP Address Method field select the method that the IP Address for the NetWay8GL will be obtained
(STATIC or DHCP), then follow the appropriate steps.
Static:
a. IP Address: Enter the IP address assigned to the NetWay8GL by the network administrator.
b. Subnet Mask: Enter the Subnet of the network.
c. Gateway: Enter the TCP/IP gateway of the network access point (router) being used.
Gateway configuration is required to properly receive emails from the device.
d. HTTP Port: Enter the HTTP port number assigned to the NetWay8GL module by the network
administrator to allow remote access and monitoring. The default inbound port setting is 80. HTTP is not
encrypted and unsecure. Even though HTTP can be used for remote access, it is recommended primarily
for use with LAN connections.