Installation Guide

NetWay8GL - 5 -
Fig. 3 - NetWayXT/NetWayXTX
Installing a NetWayXT/NetWayXTX Repeater Module:
NetWayXT will work only with PoE devices. NetWayXTX will work with PoE/PoE+ devices.
1. Mount NetWayXT/NetWayXTX in desired location utilizing the mounting hole (Fig. 3, pg. 5).
Use a proper fastener and/or wall anchor when securing NetWayXT/NetWayXTX to the wall.
2. Connect structured cable from port marked [OUT] on NetWay8GL to port marked [IN] on the
NetWayXT/NetWayXTX (Fig. 3, pg. 5).
3. Connect structured cable from port marked [OUT] on NetWayXT/NetWayXTX to the PoE/PoE+ camera/
edge device or next NetWayXT/NetWayXTX repeater (Fig. 3, pg. 5).
4. Port status LEDs will illuminate on NetWayXT/NetWayXTX indicating the port is operational
(refer to LED Definitions, pg. 5).
5. Power LED will illuminate indicating 12VDC output.
Port LED Definitions for NetWayXT and NetWayXTX Repeaters:
Status
NetWayXT NetWayXTX
Green LED Yellow LED
PoE/PoE+
Output LED
PoE/PoE+
Input LED
Yellow LED
OFF
Indicates it is
connected as 10Base-T
or no link.
Indicates no link.
No PoE/PoE+
Output
No PoE/PoE+
Input
Indicates no link.
ON
Indicates it is connected
as 100Base-TX.
Indicates a link.
Normal PoE/
PoE+ Output
PoE/PoE+ Input Indicates a link.
Blinking
– Indicates activity. – – Indicates activity.
Power
LED
Structured
Cable from
NetWayG
Structured
Cable from
NetWayG
Structured Cable
to PoE IP Camera/
Edge Device
or next
NetWayXT
PoE/PoE+
Output
LED
Structured
Cable to
PoE/PoE+
IP Camera/Device or
next NetWayXTX
Port Status
LEDs
PoE/PoE+
Input
LED
NetWayXT
NetWayXTX
NetwayXT
Repeater
IN
OUT
Power
I.T.E. 43KC
www.altronix.com
Made in U.S.A.
NetWayXT and NetWayXTX will work if the Midspan is set for 15W or 30W, but not 60W.