Installation Guide

- 6 - NetWay4BT/NetWay8BT
NetWay8BT Typical Applications:
Fig. 4
NetWay8BT
Front Panel
Card
Reader
HID Solo
Strike
Ethernet Switch
Programming
and Status
NVR/Network Server
NetWayXTG
Extends Ethernet
100m
Typical UL294
Application:
PoE/PoE+/Hi-PoE
Camera
PoE/PoE+/Hi-PoE
Camera
PoE/PoE+
Camera
NetwayXTG
Repeater
IN
OUT
PoE/PoE+
Output
PoE/PoE+
Input
www.altronix.com
Made in U.S.A.
Configuring NetWay4BT/NetWay8BT for Network Connection
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Please be sure to visit altronix.com for latest firmware and installation instructions
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Factory Default Settings
• IP Address: 192.168.168.168
• User Name: admin
• Password: admin
1. Set the static IP address for the laptop to be used for programming to the same network IP address as the
NetWay4BT/NetWay8BT. The default address of the NetWay8BT is 192.168.168.168,
E.I. 192.168.168.200.
2. Connect one end of the network cable to the network jack on the NetWay4BT/NetWay8BT and the other
to the network connection of the laptop.
3. Open a browser on the computer and enter “192.168.168.168” into the address bar. A dialog box
Authentication Required will appear requesting both user name and password.
Enter the default values here. Click on the button labeled Log In.
4. The status page of the NetWay4BT/NetWay8BT will appear. Click on the tab labeled Network Settings.
This will open the Network Setting screen. In this screen the MAC Address of the NetWay4BT/NetWay8BT
module will be found along with the Network Settings and Email Settings.
Network Settings:
In the IP Address Method field select the method that the IP Address for the NetWay4BT/NetWay8BT will
be obtained (STATIC or DHCP), then follow the appropriate steps.
Static:
A. IP Address: Enter the IP address assigned to the NetWay4BT/NetWay8BT by the network administrator.
B. Subnet Mask: Enter the Subnet of the network.
C. Gateway: Enter the TCP/IP gateway of the network access point (router) being used (gateway
configuration is required to properly receive emails from the device)
D. HTTP Port: Enter the HTTP port number assigned to the NetWay4BT/NetWay8BT module by the
network administrator to allow remote access and monitoring. The default inbound port setting is 80.
HTTP is not encrypted and unsecure. Even though HTTP can be used for remote access, it is
recommended primarily for use with LAN connections.
E. HTTPS Port: Enter the HTTPS port number assigned to the NetWay4BT/NetWay8BT module by
the network administrator to allow remote access and monitoring. The default inbound port setting
is 443. Being encrypted and more secure, HTTPS is highly recommended for remote access.
F. Click the button labeled Submit Network Settings. A dialog box will display “New network settings
will take effect after the server is rebooted”. Click OK.