Installation Guide

NetWay4BT/NetWay8BT - 5 -
Fig. 3 - NetWayXTG
Installing a NetWayXTG Repeater Module:
NetWayXTG will work with PoE/PoE+ devices.
NetWayXTG is not intended to be connected to outside plant leads.
1. Mount NetWayXTG in desired location utilizing the mounting hole (Fig. 3a, pg. 5).
Use a proper fastener and/or wall anchor when securing NetWayXTG to the wall.
2. Connect structured cable from port marked [OUT] on NetWay4BT/NetWay8BT to port marked [IN]
on the NetWayXTG (Fig. 3b, pg. 5).
3. Connect structured cable from port marked [OUT] on NetWayXTG to the PoE camera/ device or next
NetWayXTG repeater (Fig. 3b, pg. 5, Fig. 4, pg. 6 ).
4. Port status LEDs will illuminate on NetWayXTG indicating the port is operational
(Fig. 3a, pg. 5, refer to Port LED definitions below).
Port LED Definitions for NetWayXTG Repeater:
Status PoE/PoE+ Output LED Green LED Yellow LED
OFF No PoE/PoE+ Output Indicates no link. Indicates no link
ON Normal PoE/PoE+ Output Indicates 1G link Indicates 10/100 link
Blinking – Indicates 1G activity Indicates 10/100 activity
PoE/PoE+
Output
LED
Structured
Cable to
PoE/PoE+
Camera/Device or
next NetWayXTG
Port Status
LEDs
PoE/PoE+
Input
LED
NetwayXTG
Repeater
IN
OUT
PoE/PoE+
Output
PoE/PoE+
Input
www.altronix.com
Made in U.S.A.
Structured Cable from
Midspan or Endspan
(10/100/1000)
Fig. 3a
Fig. 3b
Cable Type, Total Device Power, Data and Power Distance:
Cable Type
Total Power
Consumption
Max. Data
Distance
Max. Power
Distance
CAT5e 15W 100m 846m
CAT5e 30W 100m 423m
CAT5e 60W 100m 211m
CAT5e 75W 100m 185m
CAT5e 90W 100m 158m
Note: Higher gauge wiring will allow for longer distances.