Installation Instructions

- 2 - NetWay1/NetWay1EV
Fig. 1
Technical Specifications:
Parameter Description
No. of Ports One (1)
Input power requirements
NetWay1E - 115VAC, 60Hz, 1.5A.
NetWay1EV - 230VAC, 50/60Hz, 0.8A.
Indicators Port Status and power LED
PoE Shutdown Voltage
and Current Range
5VDC to 24VDC or 12VAC to 24VAC. Maximum current: 2mA for 5VDC
Maximum current for higher voltages: 10mA.
Environmental Conditions
Operating Ambient Temperature: 85W / -20ºC to 49ºC (- 4ºF to 120ºF)
55W / -20ºC to 55ºC (- 4ºF to 131ºF)
Relative humidity: 85%, +/ --- 5%
Storage Temperature: --- 4º to 158ºF (--- 20º to 70ºC) Storage
Operating Altitude: --- 1000 ft. to 2,000 ft. (--- 304.8m to 609.6m).
Regulatory Compliance
UL/CUL Listed for Information Technology Equipment (UL 60950-1).
CE approved.
Optional Wall Mount Installation
1- Install mounting brackets (A) on the left and right side of rack chassis using
four (4) flat head screws (B) (not included) (Fig. 2a).
2- Place unit at desired location and secure with Fig. 2b
mounting screws (not included) (Fig. 2b).
Caution: It is necessary to make sure mounting
screws are securely fastened to a beam when
installing the unit horizontally. Fig. 2a
Structured
Cable from
Network Switch
12VAC to 24VAC or
5VDC to 24VDC input
for Remote Manual
PoE Shutdown
Structured
Cable to
IP Camera
--- +
PoE
ShutdownINOUT
PoE
ON
IEC 320 - 3-wire
grounded line cord
Altronix is not responsible for any typographical errors.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: [phone]
website: www.altronix.com, e-mail: [e-mail]. Lifetime Warranty, Made in U.S.A.
IINetWay1E/NetWay1EV Rev. 011612 E19P
MEMBER
B
A