Installation Instructions

Maximal11D/Maximal33D/Maximal55D/Maximal77D/Maximal75D Access Power Controllers (PTC) - 17 -
J2 J1
CUT JUMPERS
J1 AND J2
ISOLATED POWER INPUT
12 OR 24 VAC OR VDC
(LOCK POWER)
ISOLATED POWER INPUT
12 OR 24 VAC OR VDC
(ACM8 POWER)
CUT
JUMPER
FROM FACP
OUTPUT
CIRCUIT
+
--
FACP
OUTPUT EOL
TRG
NO C NC
FACP INTERFACE
JUMPER
N.C. DR
Y
TRIGGER
INPUT
TRG
NO C NC
FACP INTERFACE
N.C. TRIGGER
INPUT
N.C. RESET
SWITCH
JUMPER
TRG
N.O. TRIGGER
INPUT
TRG
NO C NC
FACP INTERFACE
N.C. RESET
SWITCH
N.O.
TRIGGER
INPUT
JUMPER
TRG
NO C NC
FACP/Optional Power Supply Hook-up Diagrams:
Fig. 12 Normally Open - Non-Latching FACP
trigger input:
Fig. 13 Normally Open FACP Latching trigger input
with reset:
(This output has not been evaluated by UL)
Fig. 14 Normally Closed - Non-Latching FACP
trigger input:
Fig. 15 Normally Closed - Latching FACP trigger input
with reset:
(This output has not been evaluated by UL)
Fig. 11 Polarity reversal input from FACP signaling circuit
output (polarity is referenced in alarm condition):
Fig. 10 Optional hook-up using two (2) isolated power
supply inputs (Only applicable on Maximal11D):