Spec Sheet
Description
Altronix MaxFit7F16AP Access Power Controller distributes and switches power to
access control systems and accessories. It converts a 120VAC, 60Hz input into six-
teen (16) distributed 24VDC fuse protected outputs and sixteen (16) independently
controlled 24VDC fuse protected relay outputs. Fail-Safe/Fail-Secure power outputs
may be converted to dry form “C” contacts. Relays are activated by an open collector
sink or normally open (NO) dry trigger input from an Access Control System, Keypad,
Push Button, REX PIR, etc. Unit will route power to a variety of access control hardware
devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. The FACP
Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger
other auxiliary devices. The fire alarm disconnect feature is individually selectable for
any or all of the sixteen (16) relay outputs.
MaxFit7F16AP
Access Power Controller
Rev. MaxFit7F16AP - 05272020
- 24VDC @ 10A power supply/charger.
- Supervision
- AC Fail
- Low Battery and Battery Presence
- Low power shutdown.
- Outputs:
- Sixteen (16) distributed 24VDC fused protected outputs.
- Sixteen (16) independently controlled 24VDC fuse protected
relay outputs.
- Convenient knockout configuration:
- Twelve (12) double knockouts (1” and 0.75”).
- 16 AWG powder-coated steel enclosure simplifies board layout
and wire management.
- Enclosure accommodates up to four (4) 12VDC/12AH batteries.
Key Features
Lifetime Warranty / Made in the U.S.A.
Altronix Corporation | 140 58th St | Brooklyn, NY 11220 USA
phone: +1 718.567.8181 | fax: +1 718.567.9056 | email: info@altronix.com | www.altronix.com
MaxFit7F16AP
Accessories
Network Supervision
Altronix model LINQ2 Network Communication Module provides remote supervision,
control and monitoring over LAN/WAN
- Remotely reports accurate power diagnostics
- Controls power and resets devices
- Reports system diagnostics via Email
™