Installation Guide

HubSat4WP - 5 -
Fig. 2 - HubSat Circuit Board
PVD1
VIDEO1 VIDEO2 VIDEO3 VIDEO4
PVD2 PVD3 PVD4
+ DATA -
DATA 1-4 VIDEO 1-4
28VAC
24VAC
28VAC
24VAC
28VAC
24VAC
28VAC
24VAC
OFF OFF OFF OFF
AUX1 AUX2 AUX3 AUX4
2a - BNC Connector: Video in from remote camera
video out to DVR.
2b - Output PTCs: Protects each output.
2c - Power Terminals: 24VAC/28VAC power outputs.
2d - Output Voltage Switches: Selects 24VAC/28VAC/
OFF for each output.
2e - LED(s) 1-4: Power output indicators.
2f - Data: RS422/RS485 input from head end equipment
(DVR) for PTZ control.
2g - Channels 1-4: Single CAT-5 or higher structured
cable out to HubWay, HubWayLD or HubWayLDH
enables transmission of up to four (4) video signals.
2h - Data: CAT-5 or higher structured cable to data port
on HubWay, HubWayLD or HubWayLDH or head
end equipment (DVR).
2i - Channels 1-4: CAT-5 or higher structured cable
to cameras.
2a
2i
2b
2c
2d
2e
2f
2g2h
2c
Fig. 3e
HubWayAv2
Video from Camera
Data to Camera
Power to Camera
Cat5
back to
HubWay
or
HubSat
VIDEO BALUN/COMBINER
CAT5 + DATA-- POWER
AC
VIDEO
HubWayAv
VIDEO
AC Power
to Camera
Data to
Camera
--
+
Data to
Camera
Green Power LED
12VDC Power
to Camera
+
--
Red Power LED
Wire
Connectors
RJ45 Jack RJ45 Jack
To BNC
Connector
of Camera
To BNC
Connector
of Camera
Structured
Cable from
HubSat4WP
Structured
Cable from
HubSat4WP
VIDEO BALUN/COMBINER
HubWayDv
CAT5 + DATA-- -- 12VDC+
--
+
Wire
Connectors
* Also Available as:
HubWayDvi
Video Balun/
Combiner
for non-isolated
12VDC cameras
Fig. 3 - HubWayAv and HubWayDv/Dvi Video Balun/Combiners
Fig. 3c
Fig. 3a
Fig. 3b Fig. 3d
HubWayAv/HubWayAv2 passes AC voltage from pins
4, 5, 7, 8 to terminals marked [AC Power] (Fig. 3, pg. 5).
HubWayDv/HubWayDvi converts AC voltage to DC
voltage from pins 4, 5, 7, 8 to terminals marked
[-- 12VDC +] (Fig. 3, pg. 5).