Data Sheet

ManualsBrandsAltronix ManualsAccess Control Power products2 Output Power Supply/Charger w/Fire Alarm

Input:

• 120VAC, 60Hz, 4.5 amp.

• Input fuse: 5A/250V.

Output:

• 24VDC @ 10.0 amp supply current.

• Auxiliary power-limited output

rated @ 1 amp (unswitched).

• Overvoltage protection.

Battery Backup:

• Built-in charger for sealed lead acid or gel type batteries.

• Maximum charge current 1.54 amp.

• Automatic switch over to stand-by battery when

AC fails. Transfer to stand-by battery power is

instantaneous with no interruption.

Supervision:

• AC fail supervision (form “C” contacts).

- Notification trigger is selectable for

30 seconds (factory set) or 2 hours.

• Battery fail and presence supervision

(form “C” contacts).

• Low power shutdown. Shuts down DC output terminals

if battery voltage drops below 70-75% (depending on

the power supply). Prevents deep battery discharge.

Fire Alarm Disconnect:

• Supervised Fire Alarm disconnect (latching or

non-latching) 10K EOL resistor. Operates on a

normally open (NO) or normally closed (NC) trigger.

Electrical:

• Operating temperature: 0º C to 49º C ambient.

• BTU/Hr.: 124.85 BTU/Hr.

• System AC input VA requirement: 540VA.

Visual Indicators:

• Green AC Power LED indicates 120VAC present.

• AC input, DC output, and Battery LED indicators.

Additional Features:

• Short circuit and overload protection.

• Unit is complete with power supply, enclosure,

battery leads and cam lock.

Mechanical:

• Enclosure Dimensions (H x W x D approx.):

15.5” x 12” x 4.5” (393.7mm x 304.8mm x 114.3mm)

- Accommodates up to two (2) 12VDC/12AH batteries.

• Product weight (approx.): 8.65 lbs. (3.92 kg).

• Shipping weight (approx.): 9.75 lbs. (4.42 kg).

Specifications

eFlow104NX

Power Supply/Charger

Rev. DSeFlow104NX_05182015

Overview

Agency Approvals

UL 294 UL Listed for Access Control

System Units.

UL 603 UL Listed for Power Supplies

for Use with Burglar-Alarms

Systems.

UL 1481 UL Listed for Power Supplies

for Fire Protective Signaling

Systems.

ULC-S318-96 - Power Supplies for

Burglar Alarm Systems. Also suitable for

Access Control.

CSFM - California State Fire

Marshal Approved.

Altronix Corp.

140 58th St. Brooklyn, NY

CE - European Conformity

eFlow104NX is a power supply/charger that converts a 120VAC 60Hz input

into a single 24VDC output with a total of 10 amps max. The unit includes an

unswitched aux. output. It also offers a suite of features that includes fire alarm

disconnect, overvoltage protection, and low power disconnect which prevents

deep discharge of stand-by batteries.

eFlow104NX

Summary of content (2 pages)

PAGE 1
eFlow104NX Power Supply/Charger Rev. DSeFlow104NX_05182015 Overview eFlow104NX is a power supply/charger that converts a 120VAC 60Hz input into a single 24VDC output with a total of 10 amps max. The unit includes an unswitched aux. output. It also offers a suite of features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries. eFlow104NX Specifications Fire Alarm Disconnect: Input: • 120VAC, 60Hz, 4.5 amp.
PAGE 2
Enclosure Dimensions (H x W x D approximate): 15.5” x 12” x 4.5” (393.7mm x 304.8mm x 114.3mm) 1.5” (38.1mm) 4.615” (117.22mm) 4.615” (117.22mm) 1.5” (38.1mm) 1.75” (44.45mm) 1.375” (34.925mm) 1.125” (28.575mm) 1.25” (31.75mm) 4.5” (114.3mm) 12.23” (310.64mm) 1.1” (27.94mm) 0.91” (23.114mm) 1.5” (38.1mm) 4.5” (114.3mm) 1.1” (27.94mm) 1.25” (31.75mm) 0.91” (23.114mm) 2.0” (50.8mm) 1.5” (38.1mm) 15.5” (393.7mm) 2.0” (50.8mm) 5.0” (127.0mm) 5.0” (127.0mm) 1.1” (27.94mm) 1.25” (31.