IP over Coax Receiver Installation Guide Models Include: eBridge4PCRX - Four (4) Channel Receiver Z1409 I.T.E. 43KC Rev. 072412 More than just power.
Overview: The eBridge4PCRX is a CAT5 to Coax cable Managed Ethernet Midspan receiver. The receiver enables fast 10/100Base-T Ethernet digital communication to be received over Coax cable. An eBridge4PCRX receiver sends power over the coax to the eBridge1PCT 15.4W (PoE) or eBridge1PCTX 30W (PoE+) transmitter under PoE protocol. The eBridge1PCT/PCTX in turn delivers that power to a PoE enabled camera or IP device.
due to uneven mechanical loading. Circuit Overloading - Consideration should be given to the connection of the equipment to supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate rating should be used when addressing this concern. Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.
Single IP camera: Fig. 2 RE2 - Rack Battery Enclosure (cross section of rear) with four (4) 12VDC/7AH batteries (Altronix model # BT126) eBridge1PCTX eBridge1PCTX BAT4 BAT3 BAT2 BAT1 + + --- --- + + --- --- + + --- --- + + --- --- eBridge1PCTX IP Camera Up to 1500 ft. eBridge1PCTX IP Camera Up to 1500 ft. Up to 1500 ft. IP Camera IP Camera Up to 1500 ft.
c. Click the Networking tab. Under this connection uses the following items, click either Internet Protocol Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6), and then click Properties. d. To specify IPv4 IP address settings, click Obtain an IP address automatically, and then click OK. e. To specify IPv6 IP address settings, click Obtain an IPv6 address automatically, and then click OK. For Windows 7: a.
take specific steps that program your router to prevent such address conflicts. 2. If using a Static IP (recommended), you will need to input the information manually. In order for DDNS to work, you must enter valid data, compatible with your network, for all of the network setting fields: IP address, Subnet Mask, Inbound Port and Host Name. 3.
eBridge4PCRX Chassis Mechanical Drawing & Dimensions: Fig. 4 Input 1 -+ 1.7” 5.23” 8.93” 8.
Shelf Installation Mounting Options: 1- Position and affix rubber pads (C) (included) at each corner on the bottom of the unit (Fig. 5). 2- Place unit in desired location. Fig. 5 Mounting Hardware (Included): A Six (6) flat head screws for mounting brackets. Left Side C B Four (4) rubber pads. Rubber Pad Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056 website: www.altronix.com, e-mail: info@altronix.