AL300ULX Series Power Supply/Charger Installation Guide Models Include: AL300ULX - Single Output. AL300ULPD4 AL300ULPD4CB AL300ULPD8 AL300ULPD8CB AL300ULXPD16 AL300ULXPD16CB - Four (4) Fuse Protected Outputs. - Eight (8) Fuse Protected Outputs. - Sixteen (16) Fuse Protected Outputs. - Four (4) PTC Protected Outputs. - Eight (8) PTC Protected Outputs. - Sixteen (16) PTC Protected Outputs. For a red enclosure add an “R” suffix to the part #, e.g. AL300ULPD8R Rev. 013019 More than just power.
Overview: Altronix AL300ULX is a power supply that converts a 115VAC, 60Hz input to a 12VDC or 24VDC regulating output (see specifications below). The AL300ULX is a base power supply unit for the UL Listed multi-output power supply/charger series: AL300ULPD4, AL300ULPD4CB, AL300ULPD8, AL300ULPD8CB, AL300ULXPD16, AL300ULXPD16CB (Refer to AL300ULX Series Power Supply Configuration Reference Chart below).
Output 12VDC 24VDC ON Power Supply Output Specifications: Switch Position SW1 - ON SW1 - OFF OFF - 24V ON - 12V Stand-by Specifications (total current shown): 4 hr. of Stand-by and 5 Minutes of Alarm 24 hr. of Stand-by and 5 Minutes of Alarm 60 hr. of Stand-by and 5 Minutes of Alarm 12VDC / 40AH Battery Stand-by = 2.5A Alarm = 2.5A Stand-by = 1.0A Alarm = 2.5A Stand-by = 300mA Alarm = 2.5A 24VDC / 12AH Battery – Stand-by = 200mA Alarm = 2.5A – 24VDC / 40AH Battery Stand-by = 2.5A Alarm = 2.
Installation Instructions: Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/NFPA 72/ANSI, and with all local codes and authorities having jurisdiction. Product is intended for indoor use only. 1. Mount unit in the desired location. Mark and predrill holes in the wall to line up with the top two keyholes in the enclosure. Install two upper fasteners and screws in the wall with the screw heads protruding.
Terminal Identification: Power Supply Board Terminal Legend Function/Description Connect 115VAC 60Hz. to these terminals: L to Hot, N to Neutral. L, G, N Do not use the [G] terminal. + DC – 12VDC or 24VDC @ 2.5A continuous power-limited output. Indicates loss of AC power, e.g. connect to annunciator/alarm panel. Relay normally energized when AC power is present. Contact rating 1A @ 28VDC. AC Fail condition will AC Fail report approximately within one (1) minute after loss of AC.
Appendix A - UL Listed Compatible Devices –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– A.1 Four (4) Wire Smoke Detectors Table A-1 below lists four (4) wire smoke detectors compatible with AL300ULX output.
Enclosure Dimensions (BC300): AL300ULX, AL300ULXR, AL300ULPD4, AL300ULPD4CB, AL300ULPD8, AL300ULPD8CB 13.5” x 13” x 3.25” (342.9mm x 330.2mm x 82.6mm) 1.40” (36mm) 4.85” (123mm) 4.85” (123mm) 1.40” (36mm) 1.20” (31mm) 3.25” (83mm) 1.20” (31mm) 0.75” (19mm) 12.5” (318mm) 11.0” (279mm) 1.20” (31mm) 0.75” (19mm) 0.9375” (24mm) 1.40” (36mm) 1.40” (36mm) 5.10” (130mm) 5.10” (130mm) 13.0” (330mm) 5.10” (130mm) 6.5625” (167mm) 0.9375” (24mm) 3.25” (83mm) 3.25” (83mm) 3.25” (83mm) 1.0” (25mm) 1.
Enclosure Dimensions (BC400): AL300ULXX, AL300ULXXR, AL300ULXPD4, AL300ULXPD4CB, AL300ULXPD8, AL300ULXPD8CB, AL300ULXPD16, AL300ULXPD16CB 15.5” x 12” x 4.5” (393.7mm x 304.8mm x 114.3mm) 1.5” (38.1mm) 4.615” (117.22mm) 4.615” (117.22mm) 1.5” (38.1mm) 1.75” (44.45mm) 1.375” (34.925mm) 1.125” (28.575mm) 1.25” (31.75mm) 4.5” (114.3mm) 12.23” (310.64mm) 1.1” (27.94mm) 0.91” (23.114mm) 1.5” (38.1mm) 4.5” (114.3mm) 1.1” (27.94mm) 1.25” (31.75mm) 0.91” (23.114mm) 2.0” (50.8mm) 1.5” (38.1mm) 15.
