Installation Guide

M220 Series Installation Guide - 7 -
Fig. 2 - AL600M220
- DC INPUT +
POS (+) DC OUTPUT (ALARM)
POS (+) DC OUTPUT (STANDBY)
6 7 8 9 10
1 2 3 4 5
TRIGGER
LED
POWER ON LED
NEG1 NEG2 NEG3 NEG4 NEG5
TRIGGER
NC C NO NC C NO
DRY OUTPUT POWER FAIL
MOM5_S
- INPUT +
BAT FAIL NC C NO NC C NO AC FAIL
AC DC
BAT
+ BAT -
+ DC -
OFF - 24V
ON - 12V
ON
L G N
AC Delay
DC Outputs to devices
Battery Connections
Wire Strap
(from Enclosure
to Door)
220VAC
power mains
Ground
Lug
Optional Rechargeable
Stand-by Battery
Optional Rechargeable
Stand-by Battery
SW1
ON
1
OFF - 24V
ON - 12V
Battery & AC
Supervision Circuit
NC C NO NC C NO
Keep power-limited wiring separate from non power-limited.
Use minimum 0.25" spacing.
CAUTION: Optional rechargeable stand-by batteries must match
the power supply output voltage setting.
CAUTION: De-energize unit prior to servicing. For continued protection
against risk of electric shock and fire hazard replace fuses with the same type
and rating (see marking on the board). Do not expose to rain or moisture.
J1
AC Delay
Fig. 2a
Fig. 2b
Fig. 2c