Installation Instructions Instruction Manual

- 2 - AL1002ULADAJ
Agency Listings:
• ULListedControlUnitsforFireProtective
 SignalingSystems(UL864).
• MEA-NYCDepartmentofBuildingsApproved.
• CSFM-CaliforniaStateFireMarshalApproved.
• FM-FactoryMutualApproved.
• NFPA72Compliant.
Input:
• Powerinput120VAC60Hz,5amp.
• Two(2)ClassA,StyleZortwo(2)ClassB,
 StyleW,YFACPinputs.
• Two(2)NCdrycontacttriggerinputs.
Output:
• Class2Ratedpower-limitedoutputs.
• 24VDC@10ampmaxtotalalarmcurrent.
• 2.5ampmaxcurrentperoutput.
• Separate1.0ampauxiliaryoutput.
• Programmablesupervisedindicatingcircuitoutputs:
 Four(4)ClassB,StyleW,YorTwo(2)ClassA,
 StyleZorOne(1)ClassA,StyleZandTwo(2)ClassB,
 StyleW,Y(see Application Guide).
•Thermalandshortcircuitprotectionwithautoreset.
Battery Backup:
•Built-inchargerforsealedleadacidorgeltypebatteries.
•Automaticswitchovertostand-bybatterywhen
 ACFails.
• Zerovoltagedropwhenswitchingoverto
 batterybackup.
Supervision:
•ACfailsupervision(form“C”contact,1amp/28VDC).
 Factorysetfor1.5hourswithoptional30seconds
 delaysetting(fieldselectable).
• InstantlocalACtroublereportingrelay
 (form“C”contact,1amp/28VDC).
•Batterypresenceandlowbatterysupervision
 (form“C”contact,1amp/28VDC).
Visual Indicators:
•InputandoutputstatusLEDindicators.
Special Features:
• 2-wirehorn/strobeSyncmodeallowsaudible
 notificationappliances(horns)tobesilenced
 whilevisualnotificationappliances(strobes)
 continuetooperate.
• SyncprotocolsincludePotter/Amseco,Faraday,
 Gentex
®
,

SystemSensor
®
,andCooperWheelock
®
.
• TemporalCode3,SteadyMode,InputtoOutput
 FollowerMode(maintainssynchronizationof
 notificationappliancescircuit).
• Compatiblewith12VDCor24VDCfirepanels.
•Outputloopsupervisionsteeredtoinput1orinput2.
• Signalcircuittroublememory(helpsidentify
 intermittentloopproblems).
• Commontroubleinputandoutput.
• Groundfaultdetection.
•Unitincludespowersupply,redenclosure,camlock,
 andbatteryleads.
Enclosure Dimensions (approx. H x W x D):
18”x14.5”x4.5”(457.2mmx368.3mmx114.3mm).
Overview:
TheAltronixAL1002ULADAJisanextremelycosteffective10ampremotepowersupply/batterycharger.Itmaybecon-
nectedtoany12or24voltFireAlarmControlPanel(FACP).PrimaryapplicationsincludeNotificationApplianceCircuit
(NACsuchasstrobesandhorns)expansionsupporttomeetADArequirements.Italsoprovidesauxiliarypowertosupport
systemaccessories.Theunitdeliverselectronicallyregulatedandfiltered24voltpowertoClassB,StyleW,YorClass
A,StyleZNACloopcircuits.Additionally,aseparate1.0Aauxiliaryoutputforfour(4)-wiresmokedetectorsisavailable.
The10ampmax.alarmcurrentcanbedividedbetweenthefour(4)outputsforpoweringNACdevices.Eachoutputis
ratedat2.5ampmax.,andcanbeindependentlyprogrammedforSteady,TemporalCode3orStrobeSynchronization.All
outputsmaybeprogrammedforInputtoOutputFollowerMode(outputwillfollowinput.i.e.MarchTimeInput,March
TimeOutput).Innon-alarmconditionindependentloopsupervisionforClassA,StyleZand/orClassB,StyleW,YFACP
NACcircuitsisprovided.Intheeventofalooptrouble,theFACPwillbenotifiedviathesteeredinput(input1orinput
2).Inaddition,therearecommontroubleoutputterminals(NC,C,NO)whichareusedtoindicategeneralloop/system
trouble.AcommontroubleinputisprovidedforoptionalNC(normallyclosed)devicestoreporttroubletotheFACP.Two
(2)FACPsignalingoutputscanbeemployedanddirectedtocontrolsupervisionandpowerdeliverytoanycombination
ofthefour(4)outputs.
Note:TheinformationinthisdocumentisvalidformodelsAL1002ULADAJandAL1002UL2ADAJ.Model
AL1002ULADAJisequivalenttomodelAL1002UL2ADAJ.
Specifications:
AL1002ULADAJ - NAC Power Extender