ACM4-Series Instructions

- 8 - ACM4 series
UL Listed Sub-Assembly Installation Instructions:
The following Altronix sub-assembly modules may be field installed in the AL300ULX(R), AL600ULX(R),
AL400ULX(R) power supply/chargers: ACM4 or ACM4CB
1. Disconnect power before proceeding with sub-assembly installation.
2. Fasten stand-offs (supplied) to the corresponding studs in the enclosure.
3. Align mounting holes of sub-assembly with stand-offs (Fig. 8, pg. 8).
Refer below for the location and position for placement of sub-assembly.
4. Fasten sub-assembly to enclosure using the four (4) screws (supplied) (Fig. 9, pg. 8).
5.
Connect red and black power leads of CM type jacketed wire (supplied), as shown below:
NC C NO COM
OUTPUT1
NC C NO COM
OUTPUT2
NO C NC
FACP
--- + --- +
Power Control
+ INP --- T + RET ---
INTERFACE
LED1
SW1 SW2
SW3
SW4
LED2 LED3 LED4
10A
3A3A3A3A
TRIGGER
INPUT
TRG
NC C NO COM
OUTPUT3
NC C NO COM
OUTPUT4
J2 J1
J3
IN GND
2
IN GND 1
IN GND 3
IN GND
4
--- DC
+
L G N
NC C NO NC C NO
+ BAT ---
AC FAIL
BAT FAIL
S
ub-Assembly
M
ounting
Holes
Divider
Red Lead
Black Lead
P
ower Supply Board for:
AL300ULX(R)
AL400ULX(R)
A
L600ULX(R)
--- + --- +
Power Control
Keep power limited wiring separate
from non-power limited.
Use minimum .25" spacing.
ACM4
Fig. 9
Enclosure Dimensions:
13.5”H x 13”W x 3.25”D
Mounting Position for
UL Listed Sub-Assembly Installation.
Screw
Sub-Assembly
Stand-off
Stud
Enclosure
Fig. 8
Terminals
P
ower Leads Power Supply Sub-Assembly
(provided) Output Input
Red Lead DC + Control +
Black Lead DC -- Control --
NC C NO COM
OUTPUT1
NC C NO COM
OUTPUT2
NO C NC
FACP
--- + --- +
Power Control
+ INP --- T + RET ---
INTERFACE
LED1
SW1 SW2 SW3
SW4
LED2 LED3 LED4
TRIGGER
INPUT
TRG
NC C NO COM
OUTPUT3
NC C NO COM
OUTPUT4
J2 J1
J3
IN GND 2
IN GND 1
IN GND 3
IN GND 4
10A
ACM4CB
Altronix is not responsible for any typographical errors.
Altronix Corp.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: [phone]
web site: www.altronix.com, e-mail: [e-mail], Lifetime Warranty, Made in U.S.A.
IIACM4/ series J09H
MEMBER