User`s manual

2
Front Panel:
2 INPUT
This control adjusts the analog input signal level. It controls both the Left (Mono)
and Right input levels simultaneously.
4 OUTPUT
This control adjusts the analog output signal level going to the amplifier or mixer
from your Verb II.
3. CONTROL ELEMENTS
SPOTLIGHT
5MIX
This control adjusts the balance between the dry signal at the input stage and
the signal processed by your Verb II. If you turn it down completely, you will not
hear and process the signal at all. In center position you will hear the original
(DRY) signal and the processed signal (WET) in equal parts, and if you turn it up
fully, you will only hear the processed (WET) signal.
6 PROGRAMS
With this big selection knob you access one of the built-in 16 Factory Presets. Choose
among a wide range of reverbs, chorus, flanger, delays and combination of them.
7 VARIATIONS
Through this control you can apply 16 different modifications for each of the original
16 Programs selected. See Section 5 "Description of Presets" for further information.
In total you have available 256 different Presets in your Verb II.
2
5
4
6
7
3
3 SIGNAL LED
The LED will light up if the input level is too high. In this case you will experience
audible distortion. If the Signal LED lights up, turn the INPUT control down until
the LED does not light up at all. Alternatively you can reduce the output level at
the instrument source.
1
1POWERLED
This LED will light up when the AC adaptor is plugged into your Verb II and the
AC outlet.
13
7. BLOCK DIAGRAM
R
LTO
OUTPUT
INPUT
MIX
VARIATIONS
010010010
SIGNAL
9
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
Flange
Chorus
Tremolo
Delay/Rev
Delay
Chorus/Rev
Flange/Rev
Rotary
Verb
T M
40 bit Digital Effects Module
Hall 3
Plate 1
Plate 2
Spring 2
Spring 1
Tape
Hall 2
Hall 1
PWR