Technical data

6
1)
Options / model variants
POSEIDON 5
3.4 Connecting the water
supply
1. Rinse the water supply hose
briefly in order to prevent
sand an other dirt particles
entering into the machine.
2. Connect water supply hose
to the machine.
3. Open water tap.
3.5 Electrical connection
CAUTION!
Before connecting devices with
voltage changeover: Check that
the pre-selected voltage on the
machine corresponds with the
voltage of the electrical instal-
lation. Otherwise the electrical
devices of the machine can be
destroyed.
NOTE!
See chapter 9.4 Technical Data
for required quantity of water
and water pressure.
In the case of poor water quality
(sand, etc.), we recommend that
a fine water filter is fitted in the
water inlet.
We recommend the use of a tex-
tile-reinforced water hose with a
nominal diameter of min. 3/4"
(19 mm).
CAUTION!
When using a cord reel:
1. Release brake of the cord
reel.
2. Unwind the cord completely.
CAUTION!
The cleaner may only be con-
nected to a correctly installed
electrical installation.
1. Observe safety instructions
in chapter 1.
2. Put the plug into the electri-
cal socket.
400V
400V
230V
230V
230V / 400V
(220V /440V)
Nilfisk
ALTO