User`s manual

17
6
SPOT
LIG
HT
4. CONTROL ELEMENTS
4.1 MONO/STEREO Input Channel Section
Your PBM8.350 UM comprises 6 mono input channels
and 2 stereo input channels, each of them including
-20dB PAD, 3-band equalizer, AUX sends, PAN and
LEVEL controls. The following content will detail the
each part.
11
11
11
11
MONO Input Channels (1 ~ 6)
CH1 through Ch6 are provided of MIC IN and LINE IN
connector. Use the XLR MIC IN connector to connect
low noise microphones preamp and low level signal,
which also feature +48V phantom power, allowing you
to connect condenser microphones. Use the 1/4" TRS
LINE IN connector to connect either a microphone or
a line level instrument such as synthesizers, drum
machines, effects processors...
Note: You shall never connect an unbalanced microphone
to the XLR connector if you do not want to damage both
the microphone and the mixer.
STEREO Input Channels (7 ~ 10)
-20dB PAD Button
Pressing this button will attenuate the input signal by
20dB. In such way you can produce increased headroom
and reduce the risk of distortion due to quite "hot"
signals.
EQUALIZER
Your PBM8.350 UM features a 3-band equalizer allowing
you to adjust the high, mid and low frequencies separately
on each channel. All bands provide a boost
or cut up to 15dB , flat at the center detent.
CH7 through CH10 are organised in stereo pair. Via the
1/4" TRS input connectors, you can connect the outputs
from stereo devices such as synthesizers, effects
processor or any stereo line level signal. If only the left
jack was connected, the input will operate in mono mode.
Via the XLR MIC IN connector, you can connect the low
level sources.
Strain Clamp
Sleeve
Tip
Ring
Sleeve=Ground/Screen
Ring=Right Signal
Tip=Left Signal
Use for Headphone
1/4" Stereo (TRS) Jack Plug
Strain Clamp
Sleeve
Tip
Sleeve=Ground/Screen
Tip=Signal
Use for Mono Line In, Mono 1/4"Jack Plugs
1/4" Mono (TS) Jack Plug
Strain Clamp
Sleeve
Tip
Ring
Sleeve=Ground/Screen
Ring=Return Signal
Tip=Send Signal
Use for Insert Points
1/4" Stereo (TRS) Jack Plug
1
2
4
3
1
2
3
4
5
6
7
8
6. INSTALLATION AND CONNECTION
DSP/FX
AUX2
POST
+10dB
-
8
0dB
HIGH
MID
LOW
MON
AUX1
PRE
PAN
+15dB
+15dB
12KHz
2.5KHz
80Hz
+15dB
+10dB
+10dB
-20 dB
PAD
Right
-15dB
-15dB
-15dB
-
8
-
8
Left
0dB
0dB
0dB
0dB
0
dB
LEVEL
CH 1
MIC IN (bal.) MIC IN (bal.)
LINE IN
(bal.)
E
P
I
S
O
R
E
N
A
W
M
O
P
L
E
P
I
S
O
R
E
N
A
W
M
O
P
L
(MONO)
R
L
CH 6
CH7- 8/TAPE