Operator`s manual

CLARKE TECHNOLOGY PB-12 Operator's Manual Page 5
How To Assemble The Machine
To assemble the machine, follow this procedure:
1. Put the machine on a bench.
2. Put the brush adjusting lever in the unlock position.
See figure 1
3. Lift the cover.
4. Remove the pivot pin from the plastic bag.
5. Put the handle in position. See figure 2
6. From the inside of the machine, slide the pivot pin
through the handle tube tongue and the main
frame. See figure 3.
7. Close the cover. Put the lever in the locking
position.
8. Install the cotter pin. See figure 4.
9. Remove the locking cam from the plastic bag.
Figure 1
Figure 2
Figure 3
Figure 4