Owner`s manual

5.1 Mains Connection
Please ensure that the MP8D is set to the correct supply voltage before plugging
the power cord into the wall outlet, use the same fuse as marked on the fuse
holder at the AC power connection. The mains connection of the MP8D is made
by using the enclosed mains cord and a standard IEC receptacle. It meets all
of the international safety certification requirements.
5.2 Audio Connection
The MP8D presents with balanced XLR & 1/4" TRS and combo connectors. It
can be interfaced in several ways to support a variety of applications without
any signal loss. The MP8D can be used on a single instrument by connecting to
the mixing console's main inserts, or on an entire mix "in-line" between a mixing
console's outputs and a power amplifier. The defective wiring may degrade the
performance of MP8D, so please use good quality screened audio cables only.
Please follow the guide below to interface MP8D without experiencing any noise
or signal loss.
7
Ok, you have got to this point and you are now in the position to operate your
MP8D successfully. However, we advise you to read carefully the following section
to be the real master of your own mix. Not paying attention enough to the input
signal level, to the routing of the signal and the assignment of the signal will result
in unwanted distortion, a corrupted signal or no sound at all. So you should follow
this procedure for every single channel:
5. INSTALLATION AND CONNECTION
Strain Clamp
Sleeve
Tip
Ring
Sleeve=Ground/Screen
Ring=Right Signal
Tip=Left Signal
Use for Headphone
1/4" Stereo (TRS) Jack Plug
Strain Clamp
Sleeve
Tip
Sleeve=Ground/Screen
Tip=Signal
Use for Mono Line In, Mono 1/4" Jack Plugs
1/4" Mono (TS) Jack Plug