User`s manual

3.2.2 AC Inlet (25)

After the correct voltage has been set you can connect the AC plug to the unit.

3.2.3 Input Connectors (26)

Either XLR or unbalanced 1/4" TRS jack input connector is used to input the signal.

3.2.4 Output Connector (27)

Either XLR or unbalanced 1/4" TRS jack output connector is used to output the signal.

4.INSTALLATION & CONNECTION

4.1 Mains Connection

A Main AC cord that meets all the international safety regulations is supplied with your Monitor. Please makeLTO

sure of the supply voltage available in your Country before plugging in the power cord into the AC socket.

4.2 Audio Connection

Balanced XLR plus 1/4" TRS connectors are available on your . In this way you canLTO Monitor PA/Monitor Processor

interface your in several different ways without experiencing any noise or signal loss. You can use yourLTO Monitor LTO

Monitor LTO Monitorwith single instruments using the mixers main insert or on the complete mix connecting the in between

the mixer and the power amplifier.

- Wiring Configuration

Either the 1/4" TRS phone jack or the XLR connector can be wired in balanced and unbalanced modes, which will be

determined by the actual application status, please wire your system as the following wiring examples:

XLR Balanced Input

XLR Unbalanced Input

1/4"TRS jack

Unbalanced Input

1/4"TRS jack

Balanced Input

- In Line Connection

For these applications the provides 1/4" TRS connector and XLR connectorLTO Monitor PA/Monitor Processor

to easily interface with most any professional audio device. Follow the configuration your particularexamples below for

connection.

Gnd/Screen

Please note the triangular markers on both sides of the fuse holder (see above figure). To change the voltage

pull the fuse holder out, rotate it 180 and push it back again. The operating voltage will be that indicated by

one of the two triangular markers.