User`s manual

Proceed as follows:
Keep the MAXIDRIVE2.3+ outputs in MUTE status (LEDs light on).
Feed a signal in on the MAXIDRIVE2.3+'s input and watch the INPUT LEVEL A-B LED ladders.
To obtain a good signal/noise ratio, i.e. an up-front distortion-free signal, keep the signal quite high, but make
certain the red CLIP LED doesn't light up continually.
Adjust the MAXIDRIVE2.3+ input gain if necessary:
Press the key until the menu LED lights up.MODE EDIT
Use the and keys to go to the page:PREV NEXT Input Gain
Press ENTER.
The display will show the page (according to the configurationINA Gain or INA&B Gain and other utilities loaded
in the memory):
7
Input G
a
in
Find out the output level setting for your mixer (or other unit) and connect it to the input of the MAXIDRIVE2.3+.
INA
GA I N
&B
.0dB0
INA
GA I N
.0dB0
4.3 First Setup
INA
GA I N
.5dB2-
INA
GA I N
&B
.0dB6+
Firstly, set the following parameters in order:shown
Output Pol. Polarity of the outputs
Xover Crossover frequencies (separation of the speaker channels)
Output Delay Alignment of the speaker enclosure components
Output Gain Levels of the outputs
Use the to change the gain value and watch the level of the signal on the LED ladders until the ideal valuesDIAL
are reached.
Then use the and keys to access to the page (if there is one, this will depend on the con-PREV NEXT INB Gain
figuration and the other utilities loaded in the memory).
Repeat the settings as explained above.
At this point, the first custom setup can be prepared.
The following is only the description of setup procedure.
The detailed specifications of each parameter are shown in the respective paragraphs of the manual.
Note: The regulation of the MAXIDRIVE2.3+'s parameters is closely related to the characteristics of the com-
ponents of the sound system. So if you're not the expert, please refer to the documentation and technical
specifications of your power amplifiers, loudspeaker enclosures, monitors, etc.. This will enable you to work
faster and safely.