User`s manual

Press ENTER.
11
A13
F
2
B24
2
x2W
The system returns to default status and the display shows the information on the PRESET that has just been
loaded.
Note: Factory PRESET #2In the example, , named "2x2W" has been loaded: Its system configuration is Input A
signal assigned to outputs 1 and 3; Input B signal assigned to outputs 2 and 4.
5.1.2 Store & Naming PRESET
Use this menu to create new PRESETS, i.e. to save all the current system settings.
To save a PRESET:
Press The page appears, by means of which it s possible to edit the name of theENTER. PRESET Naming
PRESET to be saved.
The name of the 'start' PRESET (i.e. of the PRESET currently loaded) is proposed as default. The cursor takes up
position on the first of the twelve character spaces available.
At this point:
If you decide to accept and confirm the name suggested, press ENTER.
If you want to abort procedure (for example because you've chosen the wrong memory area) andNaming
return to Store PRESET procedure, press .ESC
Store
2 U
Preset
Store
3 U
Preset
Use to reach the memory area in which the PRESET is to be saved.DIAL
Note: Factory PRESET Factory PRESETS
Factory PRESET,
User PRESET User
In this procedure, the areas aren't available, since the can not be
permanently remember that it is possible to load a modified. Nevertheless save it in a
area, modify it as required and then store it again in the same area.
Note: PRESETSScrolling through the memory areas, the display shows the number, type and name of the
contained in them:
Pr es m n
i
Naet
g
De f au l t
De f au l t
De f au l t