Owner`s manual

STER EO MODE: 50 0 W @ 4 OHM
300 W @ 8 OHM
(4 OHM MIN. L OAD)
BRIDGE MODE: 1000 W @ 8 OHM
(8 OH M MIN. LOAD)
CLASS 2 WIRING MAY BE USED
OUTPUT 2
1+ 1-
POS NEG
LEFT/MONO MAIN
OUTPU T 2
OUTPU T 1
OUTPUT 2
2+ 2-
POS NEG
RIGHT/ MONITOR
OUTPUT 1
1+ 1-
POS NEG
BRIDGE
2+ 1+
POS NEG
BRIDGE MODE
POWER
FUSE
250V T3.15AH
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
WARNING: SHOCK HAZARD - DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PASOUVRIR
SERIAL
MODEL
ST ER EO MO DE: 250 W @ 4 OH M
190 W @ 8 OHM
(4 OHM MIN. LOAD)
BRIDGE MODE: 500 W @ 8 OHM
(8 OHM MIN. LOAD)
CLASS 2 WIRING MAY BE USED
LTO
R
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
AC INPUT
100 VAC~60HZ
120 VAC~60HZ
230 VAC~50HZ
240 VAC~50HZ
Useonlywitha250Vfuse
POWERED MIXER
MODEL:
PBM8.250
MK
3. CONTROL ELEMENTS
SPOTLIGHT
4. CONTROL ELEMENTS
11
STER EO MODE: 25 0 W @ 4 OHM
190 W @ 8 OHM
(4 OH M MIN. LOAD)
BRIDGE MODE: 500 W @ 8 OHM
(8 OH M MIN. LOAD)
CLASS 2 WIRING MAY BE USED
Use it to connect your PBM8 to the main AC with the supplied AC cord. Please
check the voltage available in your country and how the voltage for your PBM8
is configured before attempting to connect your PBM8 to the main AC.
This switch is used to turn the main power ON and OFF.
36 POWER ON/OFF Switch
37 AC Inlet with FUSE Holder
REAR PANEL
These jacks are used to connect speakers. They are configured with 4-way
speakon connectors and 1/4" phone jacks. You can determine the signal that is
output to these jacks according to the setting of the AMPLIFIER MODE select
switch,aswewilldescribeinamoment.
38 SPEAKERS Jacks
: In order to avoid damage to the built-in amplifier, please pay attention
to the allowed impedance of the speaker. Very low load impedances may damage
The amplifier. Look at this plate on your PBM8 for reference.
Note
36
37
38
PBM8.250 MKII PBM8.500 MKII