Instruction manual

6
7
Accessories
Multiangle Adjusted in angles from 0
o
-
adaptor (6) 90
o
for better working posture
and cleaning of hard to get at
places as for instance barrels
or the underside of the lawn
mower. Fits all nozzles.
Extension hose 7 m extension hose increa-
sing the working range.
Brushes (13, 14) For cars and other sur-
faces. Available in
more shapes.
Tube cleaner
15 m long tube cleaner for the
cleaning of tubes and drains.
Water-sand-
For removal of paint and rust.
blasting equipment Sand available from do-it-
yourself shops.
Patio Cleaner
Equipment for quick
cleaning of patio/
drive/agstones.
Foam sprayer
(12) Equipment for the
application of foam.
Holder on the machine. Di-
stance approx. 1 m.
Detergents
Stone & Wood For agstones, brick- and
Cleaner woodwork.
Suitable for moss og algae.
Plastic Cleaner For plastic and synthetic
materials such as garden
furniture.
Metal Cleaner For cleaning of metal such as
garden tools.
Car Combi Cleaner For cars etc. With rinsing wax.
Alu Cleaner For surfaces of aluminium.
Applied with an atomizer.
Oil & Grease For cleaning of grease and
Cleaner oil on motors for instance.
Applied with an atomizer.
4.0 Maintenance
WARNING! Always disconnect the plug from the
socket prior to maintenance or cleaning.
To ensure a long and problem free working life,
please take the following advice:
l Wash out water hose, high pressure hose, spray
lance and accessories before mounting.
l Clean the couplings of dust and sand.
l Rinse the foam sprayer after use.
Any repair should always be made in an authorised
workshop with original spare parts.
4.1 Cleaning of nozzle
A clogging up in the nozzle causes a pump pres-
sure which is too high. This is why cleaning is re
-
quired immediately.
1. Stop the machine and disconnect the nozzle.
2. Clean the nozzle with the cleaning needle (11).
IMPORTANT: The needle should only be used
when the spray lance is detached!
3. Flush the spray lance backwards with water.
4.2 Cleaning of water inlet lter
Clean the water inlet lter regularly once a month or
more frequently according to use. Care-fully loosen
the lter with a screwdriver and clean it. Check that
it is intact before re-mounting it.
4.3 Cleaning of machine vents
The machine should be kept clean so as to let cool-
ing air pass freely trhough the machine vents.
5.0 Storage
The machine should be stored in a frost-free
room!
Pump, hose and accessories should always be
emptied of water prior to storing as follows:
1. Stop the machine (rotary switch in pos. O) and
detach water hose and accessory.
2. Restart the machine and activate the trigger. Let
the machine run until no more water runs through
the spray handle.
3. Stop the machine and unplug. Wind up the cable
and place it on the hook on the back of the ma
-
chine.
4. Disassemble spray handle and high pressure
hose. Press the blue button and pull the hose
simultaneously.
5. Wind up the high pressure hose. Place spray
handle, nozzles and other accessories in the
holders/store room of the machine.