Technical data

WORK AREA SAFETY
Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
DO NOT operate the laser tool around
children or allow children to operate
the laser tool. Serious eye injury
could result.
ELECTRICAL SAFETY
Batteries can explode or
leak, cause injury or fire.
To reduce this risk, always follow all instruc-
tions and warnings on the battery label
and package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
DO NOT mix battery chemistries. Dispose of
or recycle batteries per local code.
DO NOT dispose of batteries in fire.
Keep batteries out of reach of children.
Remove batteries if the device will not be
used for several months.
PERSONAL SAFETY
Stay alert, watch what you are doing
and use common sense when operating
a tool. Do not use a tool while you are
tired or under the influence of drugs,
alcohol or medication. A moment of
inattention while operating a tool may
result in serious personal injury or incorrect
measurement results.
Use safety equipment. Always wear eye
protection. Safety equipment such as dust
mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will
reduce personal injuries.
Keep the measuring tool away
from cardiac pacemakers. The
magnet plate 5 generates a field that
can impair the function of cardiac
pacemakers.
Keep the measuring tool away from
magnetic data medium and magnetically
-sensitive equipment. The effect of the
magnet plate 5 can lead to irreversible
data loss.
NOISE INFORMATION
The A-weighted sound pressure level of the audio
signal at one meter distance
is 85 dB(A).
Do not hold the tool close to your ear.
Read all instructions. Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
General Safety Rules
!
WARNING
!
WARNING
FCC Statement
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This product has been tested and found to comply with the limits for a Class B Digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio TV technician for help.
IEC 60825-1:2007-03
<
1 mW, 635 nm
- 5 -