Technical data

USE AND CARE
Use the correct tool for your application. The
correct tool will do the job better and safer.
Do not use the tool if the switch does not
turn it on and off. Any tool that cannot be
controlled with the switch is dangerous and must
be repaired.
Store idle tool out of the reach of children
and do not allow persons unfamiliar with
the tool or these instructions to operate
the tool. Tools are dangerous in the hands of
untrained users.
Maintain tools. Check for misalignment
or binding of moving parts, breakage
of parts and any other condition that
may affect the operation. If damaged,
the tool needs to be repaired before
use. Many accidents are caused by poorly
maintained tools.
Use the tool, accessories, etc., in
accordance with these instructions and in
the manner intended for the particular type
of tool, taking into account the working
conditions and the work to be performed.
Use of the tool for operations different from those
intended could result in a hazardous situation.
SERVICE
Have your tool serviced by a qualified repair
person using only identical replacement
parts. This will ensure that the safety of the tool
is maintained.
Develop a periodic maintenance schedule
for tool. When cleaning a tool be careful
not to disassemble any portion of the tool
since internal wires may be misplaced or
pinched or may be improperly mounted.
Certain cleaning agents such as gasoline, carbon
tetrachloride, ammonia, etc. may damage plastic
parts.
SAVE THESE INSTRUCTIONS.
The tool is intended for detecting
rotary lasers.
Inserting/Replacing the Battery
Alkaline batteries are recommended for the tool.
Pull the latch 11 of battery lid outward and open the battery lid 13.
When inserting batteries, pay attention to the correct polarity.
When in the case of a dead battery, the tool will beep and flash the LEDs then automatically shut down
when battery has been exhausted.
• Remove the batteries from the tool when not using it for extended periods. When
storing for extended periods, the batteries can corrode and discharge themselves.
The numbering of the product features shown
refers to the illustration of the tool on the graphic
page.
1 Button for adjustment of the
measuring accuracy
2 On/Off switch
3 Audio signal button
4 Back LEDs (Only for LR 30)
5 Magnetic mounts (Only for LR 30)
6 Reception area for the laser beam
7 Center mark
8 Direction LED “move downward”
9 Center-indication LED
10 Direction LED “move upward”
11 Latch of battery lid
12 Serial number
13 Battery lid
14 Mounting hole for M6 thread
15 Mounting Bracket (actual bracket may
be different from the diagram)
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our
accessories program.
Intended Use
Preparation
Features
- 6 -