Technical data

Selecting the Setting of the Center Indicator
With button 1, you can specify with which
accuracy the position of the laser beam is
indicated as central on the reception area:
– “Fine” adjustment
– “Medium” adjustment
Whenever switching on the tool, the accuracy
level “Fine” is set.
Direction Indicators
The position of the laser beam on the reception
area 6 is indicated:
– via the LEDs “move downward” 8, “move
upward” 10 or the center-indication LED 9 on
the front and back side of the tool.
– optionally via the audio signal (see “Audio
Signal for Indication of the Laser Beam”).
Tool too low: When the laser beam runs
through the top half of the reception area 6, the
corresponding direction LED 10 light up. When
the audio signal is switched on, a slow-beat signal
sounds. Move the tool upward in the direction of the
center line.
Tool too high: When the laser beam runs
through the bottom half of the reception area 6,
the corresponding direction LED 8 light up.
When the audio signal is switched on, a fast-beat
signal sounds. Move the tool downward in the
direction of the center line.
Tool in center position: When the laser beam runs
through the reception area 6 at the center mark 7,
the corresponding center-indication LED 9 light up.
When the audio signal is switched on, a continuous
signal sounds.
Audio Signal for Indication of the
Laser Beam
The position of the laser beam on the reception area
6 can be indicated via an audio signal.
After the tool has been switched on, the volume
level can be switched off.
To switch off the audio signal, push the audio signal
button 3.
Working Advice
Marking
When the laser beam runs through the center
of the reception area 6, its height can be
marked at the center mark 7 right and left on
the tool.
When marking, take care to align the tool exactly
vertical (for horizontal laser beam), or horizontal
(for vertical laser beam), as otherwise the marks
are offset with respect to the laser beam.
Attaching with the Magnet (see figure B)
When a mounting bracket is not required, the tool
can be attached to steel parts via the top side
using the magnet mounts 5.
Keep the tool clean at all times.
Do not immerse the tool into water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any cleaning agents or solvents.
If the tool should fail despite the care taken in manufacturing and testing procedures, repair should be
carried out by an authorized after- sales service center for Bosch power tools.
In all correspondence and spare parts orders, please always include the 10-digit article number given
on the type plate of the tool.
ENVIRONMENT PROTECTION
Recycle raw materials & batteries instead of disposing of waste. The unit, accessories,
packaging & used batteries should be sorted for environmentally friendly recycling in
accordance with the latest regulations.
Maintenance and Service
- 8 -