Hardware reference guide

Palo Alto Networks Installing the Hardware • 15
Connecting Cables to the Device
5. Tighten the thumb screws on the front of the M-100 to secure it to the rail as shown in
Figure 7. It is recommended that you tighten the thumb screws with a Phillips head or
flat-head screwdriver after tightening by hand.
Figure 7. Tightening the Thumb Screws on the M-100.
Connecting Cables to the Device
Figure 8 shows the front M-100 cable connections. Refer to Table 1 for descriptions of the front
panel interfaces and Table 2 for descriptions of the back panel interfaces.
Figure 8. Cable Connections for the Front of the M-100
CAUTION: Shielded interface cables which are grounded shall be used to ensure
agency compliance with electromagnetic emissions (EMC).
D1 / D2C1 / C2B1 / B2A1 / A2
ManagementConsole
Serial
Front