Hardware reference guide

Palo Alto Networks Installing the Hardware • 11
Equipment Rack Installation
1. Unpack the rail kit and then remove the inner rail from the outer rail and attached the
inner rail to both sides of the M-100. To do this, place the inner rail over the mounting
posts and then slide forward to lock in place. The mounting screw holes will be exposed
at which time you can use the provided screws to secure the inner rail to the M-100 as
shown in
Figure 3.
Figure 3. Attaching the Inner Rail to the M-100
1
2
2
Attach the inner rail on
both sides of the M-100.
Press the latch to disconnect
the inner rail from the outer rail.