Hardware reference guide

GlobalProtect Administrator’s Guide 105
Set Up the GlobalProtect Mobile Security Manager Verify the Mobile Security Manager Configuration
Step 3 Enroll the mobile device with the
GlobalProtect Mobile Security Manager.
1. When prompted to enroll with the GlobalProtect Mobile
Device Management, tap
Enroll.
2. When prompted to receive push notifications from
GlobalProtect, tap
OK.
3. If the certificate on the device check-in interface was not issued
by a trusted CA, you must
Install the CA certificate before you
can proceed with enrollment. If you have a passcode on the
device, you must enter it before you can install the certificate.
4. On the Install Profile screen, tap
Install to install the profile and
then tap
Install Now to acknowledge that enrollment will
change settings on the iPad. If you have a passcode on the
device, you must enter it before you can install the profile. On
the Warning screen tap
Install to continue.
5. When the profile is successfully installed, tap
Done. If you are
collecting GPS location information, the app will prompt you to
let GlobalProtect use your current location.
Step 4 Verify that the expected configuration
profiles were pushed to your device.
For example:
• If you pushed a passcode requirement to the device, you should
be prompted to set a new password within 60 minutes. Tap
Continue to change/set the passcode. Enter your current
passcode and then enter/re-enter the New passcode when
prompted and then tap Save. The dialog box should display any
requirements that your new passcode must meet.
• If you pushed an Exchange Active Sync configuration to the
device, verify that you can connect to the Exchange server and
send and receive mail.
• If you pushed a GlobalProtect VPN configuration, verify that the
device can establish a VPN connection.
• Test any web clips you pushed to the device and verify that you
can connect to the associated URLs.
• If you pushed restrictions to the device, verify that you cannot
perform the restricted actions.
Verify the Mobile Security Manager Configuration (Continued)