User`s manual

8
11. PROCESS control
3.4 The Back Panel
13
12
15 14 16
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
12. Fuse Holder / Voltage electorS
220-240V
110-120V
110-120V
220-240V
13. AC Inlet
14. Audio In
15. Audio Out
16. Sidechain Insert
This control renews any high frequencies lost through the compression process for natural sounding dynamics control,
which can be varied from OFF to 6. Please note that the enhancer control is only used when compression is taking place.
This is a dual voltage unit. Before you attempt to connect and operate the unit, please make sure that your local
voltage matches the voltage on the fuse-holder cover.
Caution: The fuse protects the AC supplies circuits of this unit. The fuse can only be changed by a qualified
technician in the event of a fault or changing the supply voltage. If the fuse continues to blow after replacing,
discontinue use of this unit before repaired.
The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers (please refer to the
above pictures), with two of these triangles opposing each other, your unit is set to the operating voltage printed
next to these markers.
To change, pull fuse-holder out and rotate 180 , then push in again.
This connector is meant for the connection of the supplied main cord. Do not insert power cord into unit until
voltage has been correctly set. Do not plug power cord into AC power until voltage has been correctly set.
These connectors are used to input the signal source. You can input the signal via the balanced 1/4" TRS phone
jack or XLR connector.
These connectors are used to output the signal. You can output the signal via the balanced 1/4" TRS phone
jack or XLR connector.
The connector can be regarded as insert point, which allows the unit to be controlled externally, of course the
connector must be stereo (Ring output/Tip input). You can also use the connector as a control input (mono
connector).
AC INPUT
95-120V/210-240V 60-50Hz
Rated power consumption 10W
FUSE
210-240V T100mAL 250VAC
95-120V 200mA 250VAC
Replace fuse with correct type only
CHANNEL 2
BALANCED
UNBALANCED UNBALANCED
TIP=INPUT
RING=OUTPUT
SLEEVE=GROUND
BALANCED
UNBALANCED
TIP=INPUT
RING=OUTPUT
SLEEVE=GROUND
BALANCED
UNBALANCED
BALANCED
OUTPUT
INPUT
SIDECHAIN
CHANNEL 1
OUTPUT
INPUT
SIDECHAIN
Pic.5: The Back Panel Layout Of The ACL2