User`s manual

7
4
5
6
8
7
9
3
10
Pic.3: Controls of the Compressor/Limiter section
3.2 Compressor Section
3. IN/OUT Switch
4. THRESHOLD Control
5. Ratio Control
6. Attack Control
7. Release Control
8. Auto Switch
9. Output Gain Control
10. Gain Reduction Meter
3.3 Dynamic Enhancer Section
11
Pic.4: Controls of the Dynamic Enhancer section
ENHANCER
PROCESS
OFF
6
1
5
24
3
Engage this switch to activate the corresponding channel. It can be used to make an A/B comparison in between
processed and unprocessed signal.
This control adjusts the threshold level for the Compressor section in the range of -40dBu to +20dBu. Signals
above this level cause compression.
The ratio between the input and output level of audio signals exceeding the set threshold level is determined
by this control. This control is manually adjustable from 1:1 to LIM:1.
This control determines how fast the compressor is to respond to audio signals that will exceed the set threshold.
It can be manually adjusted from 0.1 to 200 milliseconds.
This control determines how fast is the compressor to return to unity gain when the audio signal falls below the
set threshold level. It can be manually adjusted from 0.05 to 4 seconds.
Who needs Attack and release controls? Activate this switch and other controls will be deactivated. Attack and
release controls will be automatically set by the unit depending on the program material.
Through this control you can vary the output signal by a maximum of 20dB. In this way you can recover a level
that had been lost because of the compression process.
It indicated the gain reduction of the corresponding channel. The range displayed is 1 to 30dB.