Specifications

1. CLEANING:
Prior to leaving the factory, the fryer is tested for proper
operation with peanut oil. After testing is complete, the oil is
removed but oil residue remains. Therefore, it is necessary to
clean the fry pot before filling it with fresh oil. See
Cleaning
the Fryer
section in this manual.
2. Examine the cradle rollers. Adjust or tighten as required.
Lubricate the rollers with vegetable oil. DO NOT operate the
fryer unless the cradle rollers are in place and rotating freely.
Serious damage to the fry pot will result if the rollers are
missing or do not rotate freely.
3. Install the lift cradle onto the cradle pivot. Set the fry basket
on the lift cradle.
4. Install the filter leaf into the filter reservoir. Suction tube
O-rings are shipped from the factory installed on the suction
tube. Examine to verify one O-ring is in the groove closest to
the end of the tube. Install the assembled filter reservoir into
the fryer.
Operation and Care Manual #8451 • 5
PREPARATION PRIOR TO OPERATION