Operating instructions

Ga s Fr yer Op er a ti on & Ca re M an ua l • 5
I N S TA L L A T I O N
NOTE: To avoid equipment damage, remove the
Mobile Oil Trolley before moving this
appliance with a forklift or pallet lift.
MINIMUM CLEARANCES MUST
REMAIN UNOBSTRUCTED.
DO NOT place insulation or any other
type of materials in clearance areas.
MINIMUM CLEARANCE REQUIREMENTS
COMBUS TIBLE NON-CO MBUSTIBLE
SURFACES SURFACES
RIGHT SIDE 0" (152mm) 0" (0mm)
LEFT SIDE 0" (0mm) 0" (0mm)
BACK 6" (152mm) 6" (152mm)
FRONT 25" (635mm)
PLUS : 6" (152mm) minimum between the element swing in the
extended position and the lower edge of the exhaust hood
and filter media.
ENTRY CLEARANCE: 30" (762mm)
UNCRATED
Ne pas installer à une distance inférirure à celle
indiquée ce-dessous d'une parol en matiére
combustible: Côtés 6 pouches, Arriére 6 pouches.
D A N G E R
I
MPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
D A N G E R
AVERTISSEMENT : UNE INSTALLATION,
UN AJUSTEMENT, UNE ALTÉRATION,
UN SERVICE OU UN ENTRETIEN NON
CONFORME AUX NORMES PEUT CAUSER
DES DOMMAGES À LA PROPRIÉTÉ, DES
BLESSURES OU LA MORT.
LIRE ATTENTIVEMENT LES DIRECTIVES
D’OPÉRATION ET D’ENTRETIEN AVANT
DE FAIRE L’INSTALLATION, OU
L’ENTRETIEN DE CET ÉQUIPEMENT.
S I T E I N S TA L L A T I O N
C A U T I O N
DO NOT USE FORKLIFT FROM
FRONT OR REAR OF UNIT.
USE FORKLIFT FROM SIDE ONLY.
C A U T I O N
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.