Operating instructions

Ga s Fr yer Op er a ti on & Ca re M an ua l • 16
O P E R A T I O N
NOTE: Perform an initial Boil-Out to clean and
sanitize the fryer before operating..
Carbonized deposits along with an accumulation
of oil will eventually build-up on the interior of the
frypot as well as fryer accessories. It is important to
periodically remove these deposits, not only to
maintain fryer efficiency but also to provide the
highest product quality.
NOTE: Initial access to the
programming mode
must start with the
control in the “OF F”
position.
1. Open the front access door. With the
Kettle/Nozzle selector in the “KETTLE”
position, rotate the drain valve clockwise until
rotation stops and the drain valve is
“CLOSED.”
2. Fill the fryer to the maximum hot oil fill line
with a mixture of cold water and fryer boil-out
solution. Carefully follow the manufacturer's
directions for mixing the boil-out solution.
3. Turn the Master Power Switch (located within
the front access door) to the “ON” position.
4. Push the E L E M E N T H I L I M I T reset button.
Within a few seconds, both LED's on the
operational control panel will display
“OFF” when the Master Power Switch is
initially engaged.
DO NOT leave the fryer unattended during the
boil-out process. The fryer must be continuously
monitored for boil-over conditions, particularly in
high-altitude locations. If boil-over occurs,
immediately press the power key to the “
OFF”
position and allow the solution to cool. When the
solution has cooled, re-enter the boil-out mode.
NOTE:
To protect the pump from possible water
damage after the boilout procedure, fill the
kettle with oil and cycle through to remove
any excess water.
Before entering this program, make certain the frypot is
empty of all oil or shortening. Close the frypot drain.
Carefully follow the manufacturer's mixing directions
and fill the frypot with a mixture of cold water and fryer
boil-out solution.
Off
M
AXIMUM HOT OIL FILL LINE
M
INIMUM
HOT OIL FILL LINE
TOP BEND INSIDE
OIL KETTLE
FRO
N
T
O
F
KE
TTLE
D E L U X E C O N T R O L B O I L - O U T
A S F - 7 5 G W I T H O I L F I LT R A T I O N
CONTROL
RESET
IGNITION
ALARM
OIL
HI
-LIMIT
RESET
NOZZLE
KETTLE
SELECTOR
MASTER
POWER
SWITCH
N
OZZLE
CONNECTION
DRAIN
PUMP
CLOSED
OPEN