User Manual

Gas Fryer Operation & Care Manual 17
OPERATION
Careful observation of the finished food product will
help determine optimal filtering frequency. Filtering
the cooking oil at regular intervals will help ensure
food quality.
FOR BEST RESULTS: Do not allow the
temperature of the oil to decrease below the “Idle
Mode”temperatureof250°F(121°C)whenfiltering.
Iflteringattheendoftheday,pumpoilbackintothe
kettle while still hot. Do not allow oil to cool before
returning to kettle.
1. Openthefrontaccessdoor.WiththeNozzle
selector in the “NOZZLE OFF” position, rotate
the drain valve counterclock-wise until rotation
stops and the drain valve is in the “OPEN”
position. Power to the main control panel will
automatically switch “OFF.”
2. Allow contents of the fryer to completely drain.
3. Press the PUMP ON to allow the oil to
circulate through the drain system to flush
crumbs. Using the brushes provided, brush the
sides,bottomandundertheheatexchangersof
the fryer while the oil is circulating through the
system.
4. Press the PUMP OFF and allow contents of the
fryer to completely drain.
5. Rotate the drain valve clockwise to the
“CLOSED position.
6. Press the PUMP ON and allow the fryer
to refill to the recommended level adding
additional oil/shortening as required to
maintain proper fill level.
7. Press the PUMP “OFF” button.
8. After the frypot has completely refilled, pull out
the mobile oil trolley and discard the filter into
a proper receptacle. Clean the filter assembly
and oil trolley, if needed.
9. Replace the oil filter and return the trolley to the
proper position beneath the fryer.
10. Press and hold the ON/OFF key on
the main control panel for 1-1/2 to 2 seconds to
energize the fryer. Continue normal fryer
operation after the preheat function has been
completed.
ASF-75G OIL/SHORTENING FILTRATION
CAUTION
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN
IN OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
CAUTION
OPERATORS MUST BE MADE AWARE OF THE HAZARDS
INVOLVED IN THE OPERATION OF A HOT OIL FILTERING
SYSTEM. ON-SITE SUPERVISION DURING THE
FILTRATION PROCESS AND THE CLEANING PROCESS IS
STRONGLY RECOMMENDED.
WARNING
TO AVOID PERSONAL INJURY, USE
CAUTION WHEN SURFACES BECOME
SLIPPERY DUE TO SPILLED OR
DRIPPING OIL.