Specifications

COMBITHERM CT PROFORMANCE AND CT CLASSIC SERIES • INSTALLATION MANUAL • MN-35947 • 34.
POSITIONING ON SITE
Place the oven on a stable, non-combustible level
horizontal surface. Use the adjustable feet to overcome
an uneven floor and ensure that the unit is level.
It is strongly recommended that table top models be
mounted on a factory supplied stand or a stand that is
stable, open, and level. The adjustable oven legs should
be extended beyond the depth of the positioning ring
to allow for leveling after the oven has been placed on
the stand. The oven stand must be level. Stand legs are
adjustable. In addition, the overall height of the oven
should be positioned so
the operating controls and
shelves may be conveniently
reached from the front.
Adjust the height of floor models for smooth access of
the trolley or cart. When positioning the oven, observe
the minimum space allocation requirements shown.
Level from front-to-back and side-to-side
by means of the adjustable legs.
INSTALLATION
SITE INSTALLATION
MINIMUM CLEARANCE REQUIREMENTS
left side 0" (0mm) m i n i m u m
18" (457mm) service access recommended
right side 0" (0mm) from non-combustible surfaces
2" (51mm
) from combustible surfaces
back 4" (102mm) fo r p l u m b i n g
top 20" (508mm) f o r a i r m o v e m e n t
bottom 5-1/8" (457mm)
for legs and unobstructed air intake
NOTE: 







4" (102mm) PLUMBING
18" (457mm)
SERVICE
ACCESS
0" (0mm) FROM NON-COMBUSTIBLE SURFACES
2" (51mm) FROM COMBUSTIBLE SURFACES
NOTES:
FOR SURFACE CALLOUT DEFINITIONS & INSPECTION STANDARDS REFER 1.
TO ALTO-SHAAM’S COSMETIC GUIDELINES (A-S DOC INSP:002)
0 NEW RELEASE /2013
REV. ECO DESCRIPTION DATE APP
SHEET
TOP LEVEL ASSEMBLY
7.14
01-Feb-2012
NWW
1 of 1
SIZE
DATE:
DWG:
MENOMONEE FALLS, WI 53052-0450 U.S.A.
TITLE:
BY:
805604_MODULAR
B
The information contained in this drawing is the sole property
of Alto-Shaam, Inc. Any reproduction in part or whole without
the written permission of Alto-Shaam, Inc is prohibited.
MATERIAL AND DESCRIPTION:
0
REVISION
-
-
TOLERANCE: UNLESS SPECIFIED:
ELECTRONIC DRAWING DO NOT SCALE
NP00035
CURRENT ECO
731029
WT
PROJECT
FABRICATED 0.020"
WELDED 0.060"
MACHINED 0.010"
HOLE DIA 0.010"
ANGULAR 1.0
Positioning
Rings
Adjustable
Legs
Adjustable
Leg
Positioning
Ring