Specifications


INSTALLATION
SITE INSTALLATION
The Alto-Shaam Hot
Well must be installed
in a location that will
permit it to function for
its intended purpose
and to allow adequate
clearance for ventilation,
proper cleaning, and
maintenance access.
1. The hot well must be installed on a stable and
level surface.
2. DO NOT install this appliance in any area
where it may be affected by any adverse
conditions such as steam, grease, dripping
water, high temperatures, or any other severely
adverse conditions.
3. DO NOT store or use any flammable liquids or
allow flammable vapors in the vicinity of this
oven or any other appliance.
4. This appliance must be kept free and clear of
any combustible materials.
5. The outer walls of the hot well can reach
200°F (93°C) to 260°F (127°C). Verify countertop
material temperature rating with manufacturer
before installing to ensure counter can
withstand heat.
LEVELING
The heated
well should be
leveled before the electrical supply
is connected. Level the appliance from side-to-
side and front-to-back with the use of a spirit
level. For appliances installed on a mobile stand,
it is important that the floor surface be level due
to the probability of frequent repositioning.
NOTE
It is important to apply a food grade silicone
underneath the decor flange to seal flange to
the countertop.
®
DANGER
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH,
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
CAUTION
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.
DANGER
DO NOT store or use gasoline or other
fl ammable vapors or liquids in the
vicinity of this or any other appliance.
CAUTION
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN
IN OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
OPTIONS AND ACCESSORIES
Pan Divider Bars
Full Size 16019
Half Size / Third-Size 11318
Extra Long
(-HW/D  D ) 1012405
CLEARANCE REQUIREMENTS
4" (102mm)  