User Manual

Lighting
BRINGING IMAGINATION TO LIGHT
Lighting
BRINGING IMAGINATION TO LIGHT
ManualOPERATION
Spectra Series
57 Alexander St., Yonkers, NY 10701 Tel: [phone] Visit our website at www.altmanlighting.com
© 2012 Altman Stage Lighting, Inc.
15
Select DMX start address
• This is the start address of the  rst output of the  xture.
• Total amount of addresses per  xture depends on  xture
con guration and number of cells.
• Default address is 1.
Select network resolution:
• Change between 8 and 16 bit resolution.
• Using 16 bit gives you 2 addresses per output: Address 1 - Coarse,
Address 2 - Fine.
Interpolation modes:
To get the mose optimized dimming performance for di erent
applications. Default is COLR.
Select Show:
Select one of the pre-programmed shows
• 1 - Static, all outputs 100%
• 2 - Static, R 100%
• 3 - Static, G 100%
• 4 - Static, B 100%
• 5 - Static, A 100%
• 6 - RGB color change
• 7- RGBA color change
• 8 - RGB+A color shift
• 9 - All outputs o
Default is show 1
Set speed:
• Set the show speed between -99 and 99.
• Default is 0
Enable Chase mode:
• Selects the show chasing mode for more dynamic e ects.
• Default is OFF
DMX Mode parameter selection
SHOW Mode parameter selection
Con guration of the operation of the Spectra Strip while in DMX mode, responding to a DMX control signal.
Con guration of  xture operation while operating as a Stand-alone  xture or Master  xture.
While in DMX MODE
DMX ADDR
SHOW
NETWRES
SPD
INTERPOL
CHAS
-+
-+
-+
-+
-+
-+
M
M
M
M
M
M
0 » 512
1 » 9
-99 » 99
8 bit
16 bit
OFF
VID
COLR
WHIT
GLOW
OFF
ON
Display o
Display o
M
M
While in SHOW MODE