User Guide

PCB Design training module 4 - 72
10.2 Exercise – Working with polygons
In this exercise, you will place a polygon plane covering the top layer of the Temperature Sensor
PCB.
Figure 51. Placement of a solid polygon on the Temperature Sensor PCB.
1. Place a solid polygon on the top layer covering the entire PCB, connected to net GND, with the
Pour Over All Same Net Objects option selected.
2. Perform a final design rule check (DRC) to ensure there are no problems with your board.
Refer to section 7 to refresh your memory on checking the design rules.
3. Save the board.