Installation Guide
Table Of Contents
- Preface
- Contents
- 1 Introduction
- 2 Safety requirements
- 3 Physical description
- 4 Installation prerequisites
- 6 Installing the iRM4451
- 6.1 Assembling cables
- 6.2 Routing pre-assembled power/GigE optical fronthaul/grounding cables
- 6.3 Installing the iRM4451 mounting bracket
- 6.4 Hoisting the iRM4451 on elevated structures
- 6.5 Installing the iRM4451 on the mounting bracket
- 6.6 Connecting the grounding cable
- 6.1 Connecting the RET cables
- 6.1 Connecting the GigE optical fronthaul cables
- 6.1 Connecting the –48 V dc power cable
- 6.2 Checking power
- 6.3 Installing the solar shield
- 7 Terms, Acronyms and Abbreviations
- 5 iRM4451 installation overview
Installing the iRM4451
6-4 iRM4451 RRH Product Description and Installation Guide
NOTE
The iRM4451 is shipped from the factory with the mounting plate pre-
installed on the chassis as shown in
Figure 6-14.
Figure 6-14 iRM4451 mounting plate
6.3.1 Mounting on a pole/mast
The following procedure provided instructions for mounting the iRM4451 on a pole/
mast using the supplied mounting bracket assembly.
To install mounting plate on a pole or mast:
1. Install the mounting bracket and mounting c
lamp onto the pole/mast with
mounting hardware as shown in Figure 6-15.