User's Manual
Table Of Contents
- Preface
- Contents
- 1 Introduction
- 2 Safety requirements
- 3 Physical description
- 4 Installation prerequisites
- 6 Installing the iRM4451
- 6.1 Assembling cables
- 6.2 Routing pre-assembled power/GigE optical fronthaul/grounding cables
- 6.3 Installing the iRM4451 mounting bracket
- 6.4 Hoisting the iRM4451 on elevated structures
- 6.5 Installing the iRM4451 on the mounting bracket
- 6.6 Connecting the grounding cable
- 6.1 Connecting the RET cables
- 6.1 Connecting the GigE optical fronthaul cables
- 6.1 Connecting the –48 V dc power cable
- 6.2 Checking power
- 6.3 Installing the solar shield
- 7 Terms, Acronyms and Abbreviations
- 5 iRM4451 installation overview
Physical description
iRM4451 RRH Product Description and Installation Guide 3-3
3.1 iRM4451 boards and modules
The iRM4451 Remote Radio Head is an integral unit with no user accessible boards or
modules.
3.2 iRM4451 controls, indicators connectors and components
There are no controls on the RRH. The connectors are located on the bottom of the
unit. They are for Global Positioning System antenna (GPS), Power (–48v DC), RF
(ANT 1–4), Fronthaul (FH1/FH2), Ground ( ), and Remote Electrical Tilt (RET).
LEDs for Fronthaul 1 (FH1), Fronthaul 2 (FH2), STATUS, and POWER are located on
the side of the unit and are visible when the solar shield is installed.
Connector locations for RF input/output are shown in Figure 3-3. Connector locations
for –48V dc Power and Remote Electrical Tilt are shown in Figure 3-4. Connector
locations for GPS antenna and fronthaul are shown in Figure 3-5.
Figure 3-3 iRM4451 RF connectors location
Working temperature (non-condensing
humidity
–40°F to 131°F (–40°C to 55°C)
Operating altitude –197 to 9,843 ft (–60 to 3000 m)
Relative humidity 5 to 100%
Cooling Convection (fanless)
Table 3-1 Altiostar Networks iRM4451 technical specifications (continued)
iRM4451 Technical Specifications