User`s guide

SWITCHERS

APPLICATION DIAGRAM 5

INSTALLING YOUR SWITCHER 6

Step 1. Make sure that the power input is set to the

proper AC voltage for the country of usage.

An incorrect setting may result in unit

damage not covered by warranty.

Step 2. Connect the power cord to the unit and

plug it into the power outlet.

Step 3. Connect the cables from the video sources

and the audio sources (computers, VCR,

etc.) to the input channels and connect the

display devices (monitor or projector) and

the appropriate audio equipment (mixer,

amplifier, etc.) to the outputs. Shielded,

high quality coaxial cables are

recommended for video cable runs.

Step 3. Test all the required switching features. If

you experience difficulties or abnormal

switching, you may wish to reset the unit to

factory defaults to make sure that you have

not entered a particular operation mode.

To reset the switcher, unplug the unit and

then plug it in again while pressing and

holding the STAND BY button on the

front panel. For additional information on

the control of the switcher with a third-party

control system or a computer, please refer

to the RS-232 protocol in section 7.

Step 4. Verify that the display and audio equipment

operates properly and results in perfect

images and sound.

CONGRATULATIONS! YOU ARE DONE.

If you experience any problems, please call

1-800-258-4623 or 1-714- 990-2300 for

international calls.