SWITCHER MANUAL PART NUMBER: 400-0365-002 MX2106AV 2X2 VGA + 3.
SWITCHER TABLE OF CONTENTS Page PRECAUTIONS / SAFETY WARNINGS .............. 2 GENERAL.......................................................... 2 INSTALLATION ................................................. 2 CLEANING ........................................................ 2 FCC / CE NOTICE ............................................. 2 ABOUT YOUR SWITCHER.................................. 3 TECHNICAL SPECIFICATIONS .......................... 3 DESCRIPTION OF MX2106AV ............................
SWITCHER PRECAUTIONS / SAFETY WARNINGS 1.5 FCC / CE NOTICE 1 Please read this manual carefully before using your MX2106AV Switcher. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MX2106AV and to prevent fire and shock hazard. Please read them carefully and heed all warnings. • This device complies with Part 15 of FCC Rules.
SWITCHER ABOUT YOUR SWITCHER 2 MECHANICAL Material Finish Height (inches) Width (inches) Depth (inches) Weight (pounds) Ship Weight (pounds) T° Operating T° Maximum Humidity MTBF (calculations) MX2106AV 2-In, 2-Out VGA+3.5mm AUDIO Auto-Switcher The MX2106AV is a 2-In, 2-Out VGA + 3.5mm AUDIO Auto-Switcher. The MX2106AV automatically switches on signal detection, but may also be controlled manually if desired. The MX2106AV is designed to switch VGA signals and stereo audio. Table 2.
SWITCHER DESCRIPTION OF MX2106AV 4 4
SWITCHER APPLICATION DIAGRAM 5 DIAGRAM 1: TYPICAL CONFIGURATION In addition to automatic switching, the MX2106AV may be controlled manually with an external switch, or using ASCII commands over the RS-232 bus. If a remote switch is connected to the INPUT SELECT jack, INPUT 1 will be selected when the contact is open. INPUT 2 will be selected if the channel select contact is closed. If the RS-232 cable is connected, the user may send the command [ON1] to select input 1 or [ON2] to select input 2.
SWITCHER DIAGRAM 2: INTERNAL VIEW INPUT1 INPUT2 SIGNAL DETECT OUTPUT1 VGA INPUT1 VGA OUTPUT2 INPUT2 OUTPUT1 3.5mm AUDIO 3.5mm AUDIO INPUT1 OUTPUT2 INPUT2 2.
SWITCHER INSTALLING YOUR SWITCHER 6 OPERATION Step 1. Make sure that the correct power adapter is used. The Altinex power adapter is supplied with the unit. Connect the power adapter to the power port. The INPUT 2 indicator light should be ON and GREEN. There are no settings to adjust on the MX2106AV Auto-Switcher. The MX2106AV will operate successfully as long as cables are attached properly and other specifications are followed.
SWITCHER TROUBLESHOOTING GUIDE Solution 3: Bypass the switcher and connect the output of the source directly to the display. If the display is good, then call ALTINEX at (714) 990-2300. 8 We have carefully tested and have found no problems in the supplied MX2106AV unit. However, we would like to offer the following suggestions: 8.3 NO DISPLAY 8.1 LEDs ARE OFF Cause 1: The power adapter is installed wrong. Cause 1: The source has a problem.
SWITCHER ALTINEX POLICY 9 9.1 LIMITED WARRANTY/RETURN POLICY Please see the Altinex website at www.altinex.com for details on warranty and return policy. 9.2 CONTACT INFORMATION ALTINEX, INC 592 Apollo street Brea, CA 92821 USA TEL: 714 990-2300 TOLL FREE: 1-800-ALTINEX WEB: www.altinex.com E-MAIL: solutions@altinex.
