User`s guide

MULTI-TASKER
12
Example:
To group cards #1, 2, and 3 as group 5 of unit
#1, send the command [WRC1C2C3G5U1].
After executing this command, cards 1, 2, and 3
of unit 1 will be grouped as group 5.
12. [CLR]
This command clears the members for a single
group or for all nine groups.
Command Format: [CLRGkUi]
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
Example:
a) To clear group #1, send the [CLRG1U1]
command. This command clears the
members for the specified group only.
b) To clear all groups of unit 1, send the
[CLR G[U1] command.
13. [G]
This command is used to request group data.
With the command, the user can identify which
input or output of a particular group is on.
Command Format: [GkUi]
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
Example:
If group 1 has DA Cards with output 1 and 2 on,
while group 2 has SW Cards with input 2 on:
1) [G1]: will return feedback as [On12G1].
2) [G2]: will return feedback as [On2G2].
14. [RD]
This command displays the members in each
group.
Command Format: [RDGkUi]
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
members = C1 - C19 (card 1 to 19)
(1-8 for MT100-101 or 1-4 for MT100-106)
Example:
To read member data for group 1 of unit 1,
send the [RD] command. The system will return
feedback as C1C2C3 G5U1.
15. [HELP]
This command displays all information available
for user Multi-Tasker interface commands.
7.3 SUMMARY OF COMMANDS
1) [VER] Receives software version
2) [Ci] Receives status of the card
3) [CiS] Saves card configuration
4) [SIGCi] Check for input signal presence
5) [ON] Turns on one or more outputs for
a single card or a group of cards
6) [OFF] Turns off one or more outputs for
a single card or a group of cards
7) […S] Save the command configuration
sent
8) […P] Sets the path, preload for [SW]
9) […F] Provides feedback upon sending
10) [SW] Switch (outputs the preloaded
buffer)
11) [WR] Groups multiple cards
12) [CLR] Reset card configuration or
clears members of a single group
or all groups
13) [G] Requests group data
14) [RD] Displays the members in each
group
15) [HELP] Display all available commands