User`s guide

MULTI-TASKER
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
MT100-101 8-Slot Multi-Tasker™ Enclosure. Keep
this manual handy for future reference. These
safety instructions are to ensure the long life of
your MT100-101 8-Slot Multi-Tasker™ Enclosure
and to prevent fire and shock hazard. Please read
them carefully and heed all warnings.
1.1 GENERAL
• Qualified ALTINEX service personnel, or their
authorized representatives must perform all
service.
1.2 INSTALLATION
• To prevent fire or shock, do not expose this
unit to rain or moisture. Do not place the
MT100-101 in direct sunlight, near heaters or
heat radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam
can harm internal components.
• Handle your MT100-101 carefully. Dropping or
jarring can damage the unit. If the MT100-101
is not used for an extended period, disconnect
the power cord from the power outlet or turn
off the main connection.
1.3 RACK-MOUNT INSTALLATION
• Use only ALTINEX supplied MB1003 rack-
mount ears for mounting the MT100-101 into a
rack.
• The maximum operating ambient temperature
is 50 degrees Centigrade.
• When installing the MT100-101 into a rack,
distribute individual units evenly, otherwise
hazardous conditions may be created by an
uneven weight distribution. This will reduce
heat build up and will prolong the life of the
MT100-101. Power should be connected using
provided 3-prong power cord only.
Furthermore, make sure that the rack is
properly grounded.
1.4 CLEANING
• Unplug the MT100-101 power cord before
cleaning.
• Clean surfaces with a dry cloth. Never use
strong detergents or solvents such as, alcohol
or thinner. Do not use a wet cloth or water to
clean the unit.
1.5 FCC NOTICE
• This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference that may cause
undesired operation.
• This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This equipment
generates, uses, and can radiate radio
frequency energy and if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
• Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could
void the user’s authority to operate the
equipment.