User`s guide

MULTI-TASKER™
400-0394-004
8
The Unit ID has a value from 0 to 9. Unit ID 0
should be used for single unit operation. If the
Unit ID is set to zero, each command may be
used without Ui. Use the command [SETU0],
as explained in the MT100-100 User’s Guide.
Example:
[VERC3]: For Unit ID Zero
[VERC3Ui]: For Unit ID other than Zero
[VERC3]: Equivalent to [VERC3U0]
1. [C]
This command receives the status of the card.
Command Format: [CnUi]
Cn = card ID (n = # from 1 to max slots)
Ui = unit id (i = 0 to 9)
Example:
There is one MT106-103 card in slot 4. Sending
the command [C4] to the Multi-Tasker™ will
yield feedback similar to the following:
Input: Composite Video
Output Resolution: 1024x768
Brightness: 24
Contrast: 40
Color: 24
Sharpness: 10
Hue: 0
3D Filter ON
NR ON
Aspect Ration 4:3
Freeze OFF
If there is no card in slot 4, sending the [C4]
command will not return any feedback.
2. [CLR]
Reset the card to the last saved settings.
Command Format: [CLRCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [CLRC4] to reset the card in
slot 4 to the last saved settings.
3. [VER]
This command displays the software version
and model number for the card.
Command Format: [VERCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [VERC2] to check the
version of the MT106-103 in slot 2. The system
will return the following feedback:
MT106-103 690-0187-004
MT106-103 = Model Number
690-0187-004 = Firmware Version
4. [IN]
This command selects the input port on the card
to be used as the source. None of the picture
settings, like brightness and color, are changed
Command Format: [INyCnUi]
y = Resolution (y = # from 0 to 3)
0 = S-Video
1 = Composite Video
2 = PC Bypass
3 = YPbPr Video
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [IN0C4] to select the
S-Video input.
5. [INR]
This command selects the input port on the card
to be used as the source and recalls its
previously saved settings.