User`s guide

MULTI-TASKER™
400-0394-004
15
Example:
The cards in slots 2, 4 and 6 are part of
group 5. Read the member data for group 5, by
sending the command [RDG5]. The system will
return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 (Group 5) and then the
cards that make up Group 5. In this case,
Group 1 includes C2, C4 and C6.
31. [CLRG]
This command clears the members for a single
group or for all groups. The clear command
restores the cards to default settings and is the
equivalent to sending the [CLR] command to
each individual card.
NOTE: Since this command is sending the
[CLR] command to its group members,
each card will display its own reset
message, if any.
Command Format: [CLRGkUi]
Gk = Group ID (k = # from 1-8, or * for all)
Ui = Unit ID (i = # from 0-9)
Example:
1) To clear group 1 of Unit ID 0, send the
[CLRG1] command. This command clears
the members for the specified group only.
2) To clear all groups of Unit ID 1, send the
[CLRG*U1] command.
32. [CLM]
This command removes the members in a
group and leaves the group empty.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 of Unit ID 1 contains the cards in slots
2, 4 and 6. Read the member data for group 5
of Unit ID 1. Send the command [RDG5U1] and
receive the following feedback:
[G5=C2C4C6]
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
[G5=0]
7.3 SUMMARY OF COMMANDS
Card Commands
1) [C] Receives status of the card
2) [CLR] Resets card to defaults
3) [VER] Receives software version
4) [IN] Select input port
5) [INR] Select input and recall
settings
6) [MODER] Select output resolution
7) [BRIGHTm] Set or select Brightness level
8) [BRIGHT] Set or select Brightness level
9) [CONTRm] Set or select Contrast level
10) [CONTR] Set or select Contrast level
11) [COLORm] Set or select Color level
12) [COLOR] Set or select Color level
13) [SHARPm] Set or select Sharpness level
14) [SHARP] Set or select Sharpness level
15) [HUEm] Set or select Hue level
16) [HUE] Set or select Hue level
17) [MODET] 3D Comb Filter ON/OFF
18) [MODEN] Noise Reduction ON/OFF
19) [MODEA] Aspect Ratio Wide/Standard
20) [FREEZ] Freeze the displayed image