User`s guide

MULTI-TASKER™
400-0394-004
10
10. [CONTR]
This command is used to make the contrast
function active for use with the [+] and [-] control
commands.
Command Format: [CONTRCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [CONTRC1] to select the
contrast function on C1. Then use the [+] and
[-] commands to increase or decrease the
contrast level as desired.
11. [COLORm]
This command sets the color level to an
absolute value.
Command Format: [COLORmCnUi]
m = Level (m = # from 0 to 48,default=24)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [COLOR12C3] to set the
output color level to 12 on the card in slot 3.
12. [COLOR]
This command is used to make the color
function active for use with the [+] and [-] control
commands.
Command Format: [COLORCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [COLORC3] to select the
color function on C3. Then use the [+] and [-]
commands to increase or decrease the color
level as desired.
13. [SHARPm]
This command sets the sharpness level to an
absolute value.
Command Format: [SHARPmCnUi]
m = Level (m = # from 0 to 48,default=10)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [SHARP05C1] to set the
output sharpness to 5 on the card in slot 1.
14. [SHARP]
This command is used to make the sharpness
function active for use with the [+] and [-] control
commands.
Command Format: [SHARPCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [SHARPC1] to select the
sharpness function on C1. Then use the [+] and
[-] commands to increase or decrease the
sharpness level as desired.
15. [HUEm]
This command sets the hue level to an absolute
value.
NOTE: The Hue adjustment does not apply to
Component Video.
Command Format: [HUEmCnUi]
m = Level (m = # from 0 to 48,default=0)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [HUE30C1] to set the
output hue level to 30 on the card in slot 1.